TRACTOR SUPPLY 65022 Front Mounted Receiver Installation Guide
- June 6, 2024
- Tractor Supply
Table of Contents
TRACTOR SUPPLY 65022 Front Mounted Receiver
Installation Instructions
Receiver Shown In Proper Position
Equipment Required
Fastener Kit: K65022
Wrenches: 3/4”, 15mm, 18mm
Drill Bits: 5/8”
CAUTION: HOLD HANDLENUT IN PLACE TO PREVENT IT FROM ROTATING INTO AIR CONDITIONING CONDENSER.
CARGO CAPACITY – DO NOT EXCEED 500 LB. OR VEHICLE FRONT GROSS AXLE WEIGHT RATING. (GAWR)
9000| LB. MAX. WINCH LINE PULL
| ① | Qty. (4) | Handle Nut, 1/2” |
|---|---|---|
| ② | Qty. (4) | Spacer, 1-1/2” x 2” x 1/4” |
| ③ | Qty. (4) | Conical Washer, 1/2” |
| ④ | Qty. (4) | Hex Bolt, 1/2”-13 x 1-3/4” |
NOTE: OPTIONAL OEM FOG LIGHTS MUST BE REMOVED FOR RECEIVER INSTALLATION.
- Remove six (6) bumper bolts, bumper and (2) shim plates if present.
- Remove OEM tow hooks if present.
- Place bumper on protected surface to prevent scratching. Place receiver inside bumper. See Figure 2.
- Loosen six (6) nuts to remove lower front cross member (if equipped).
- Center receiver hole pattern side to side on bumper hole pattern. Mark location of drilled holes in bumper, in center of receiver slots. See Figure 3.
- Remove receiver from bumper and drill marked holes with 5/8″ drill.
- Place receiver on frame.
- Reinstall lower front cross member (if equipped).
- Reinstall OEM tow hooks removed in Step 2.
- Reinstall bumper using four (4) fasteners removed in Step 1. Do not install shim plates.
- Install remaining fasteners as shown in Figure 1. CAUTION: HOLD DRIVER’S SIDE HANDLE NUTS IN PLACE TO PREVENT THEM FROM ROTATING INTO AIR CONDITIONG CONDENSER.
- Return shim plates to customer
Tighten all fasteners with torque wrench to 50 Lb.-Ft (68 N-m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>