dweLED 611-LED Pendant PD-61110 Instruction Manual

dweLED 611-LED Pendant PD-61110 Instruction Manual

CAUTION: To prevent electrical shock, ensure electricity has been turned off at the circuit breaker before beginning.

• Read all instructions before installing.
• System is intended for installation by a licensed electrician in accordance with the National Electrical Code (NEC) and local regulations.
• When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.
• Retain installation instructions for future maintenance reference.

Warning: All parts must be used as indicated in these instructions. This product is designed for use only with the supplied parts and/or accessories designated for use by dweLED. Substitution of parts or accessories not designated for use with this product by dweLED could result in personal injury or property damage, and will void the warranty. Contact an authorized dealer or the manufacturer if any parts are  damaged or missing.

Maintenance Note: Coastal conditions may cause mineral and residue build- up on the fixture. We recommend that customers in coastal areas clean all external surfaces of the Fixture once every two weeks with a wet cloth.

HARDWARE

INSTALLATION INSTRUCTION

Preparation

1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.

MOUNTING THE FIXTURE

3. Remove the mounting screw (C) from the fixture.
4. Choose number of rods suitable for your application. Thread the fixture wire through the rods, swivel and canopy, connect swivel, rods and fixture body. Ensure all are tightened.

CONNECTING THE WIRES

5. Cut the extra wire thread from the fixture. Connect the driver input wire with
   junction box as shown in Fig.2, make sure that all wire connectors (B) are secured. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Other wise, connect the fixture’s ground wire directly to the back plate using the GND screw provided. After wires are connected, tuck them carefully inside the junction box.
   Note: Due to limited room within the canopy, shorten the cable as necessary to make the installation easier. Make sure to identify and label all the wiring properly before any trimming/shortening.(Fig. 3)

COMPLETING THE INSTALLATION(Fig. 1,2,3,4)

6. Secure mounting plate to the junction box using junction box screw.
   Note: (i) using any other non-original-manufacturer provided junction box screw may result in safety issue; (ii) The side of the mounting plate marked “GND” must face out.

7. Connect the driver’s output wires to fixture wire as shown in Fig. 3, red to the red, and black to the black, make sure that wire connectors (B) are secured. Then tuck them inside the canopy.

8. Secure the fixture by mounting the canopy to the ring of the back plate. Turn and rotate the canopy in the direction of the arrow until it stops. Fasten he canopy to the mounting back plate using the mounting screw(C) .

9. Rotate the glass onto the lamp body.

10. For slope ceiling application, rotate swivel at the top of the stem to ensure luminaries is aiming down (Fig. 4).
    

dweLED.com
Phone (800) 526.2588
Fax (800) 526.2585

Headquarters/Eastern Distribution center
44 Harbor Park Drive
Port Washington, NY 11050

Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122

Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>