MeTra 99-7349B Single Dash Kit Installation Guide
- June 6, 2024
- Metra
Table of Contents
99-7349B
INSTALLATION INSTRUCTIONS
U.S. Patent # D716,791
Kia Soul 2012-2013
KIT FEATURES
- DIN radio provision with pocket
- Painted matte black
KIT COMPONENTS
- A) Radio trim panel
- B) Radio brackets
- C) Pocket
- D) (4) #8 x 3/8” Phillips screws
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: 70-7304 • AX-HYKIA1-SWC & AX-HYKIA-SPDIF (for amplified
models) Antenna Adapter: Not required
TOOLS REQUIRED
- Panel removal tool
- Phillips screwdriver
DASH DISASSEMBLY
-
Unclip and remove the panel (and speaker, if equipped,) from above the radio panel. (Figure A)
-
Unclip and remove the radio/climate control trim panel. (Figure B)
-
Remove (4) Phillips screws securing the climate control panel. Slide the panel out and set it to the side. (Figure C)
-
Remove (4) Phillips screws securing the radio. Slide the radio out, then unplug and remove the radio. (Figure C)
-
Remove (4) screws securing the hazard switch assembly from the radio, then secure the assembly to the 99-7349B radio trim panel using the same factory
screws. (Figure D)
Continue to Kit Assembly
KIT ASSEMBLY
-
Secure the radio brackets to the pocket using the (4) #8 x 3/8” Phillips screws provided. (Figure A)
-
Remove the metal DIN sleeve and trim ring from the aftermarket radio.
-
Slide the radio into the bracket/pocket assembly, then secure it using the screws supplied with the radio. (Figure B)
-
Clip the radio trim panel over the radio/ pocket/bracket assembly. (Figure B)
-
Locate the factory wiring harness and antenna connector in the dash. Metra recommends using the proper mating adapters from Metra or AXXESS. Test the
radio for proper operation. -
Secure the radio assembly to the dash using the factory screws.
-
Reassemble the dash in reverse order of disassembly.
IMPORTANT
If you are having difficulties with the installation of this product, please
call our Tech Support line at 1-800-253-TECH. Before doing so, look over the
instructions a second time, and make sure the installation was performed
exactly as the instructions are stated. Please have the vehicle apart and
ready to perform
troubleshooting steps before calling.
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by enrolling in the most
recognized and respected mobile electronics school in our industry. Log onto
www.installerinstitute.com or call
800-354-6782 for more information and
take steps toward a better tomorrow.
Metra recommends MECP certified technicians
Metra. The World’s Best Kits.®
MetraOnline.com
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
REV. 12/3/20 INST99-7349B