CONAIR BE200 Reflection Mirror LED Lighted Mirror Instruction Manual
- June 6, 2024
- ConAir
Table of Contents
CRYSTAL
CLEAR
LIGHTED
MAKEUP MIRROR
INSTRUCTION GUIDE
For your safety and continued enjoyment of this product,
always read the instruction book carefully before using.
IMPORTANT SAFETY INSTRUCTIONS
WHEN USING ELECTRICAL FURNISHING, BASIC PRECAUTIONS SHOULD ALWAYS BE TAKEN, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS BEFORE USING THIS FURNISHING
DANGER – TO REDUCE THE RISK OF ELECTRIC SHOCK, ALWAYS UNPLUG THIS FURNISHING FROM THE ELECTRICAL OUTLET BEFORE CLEANING OR SERVICES AFTER CLEANING
WARNING – TO REDUCE THE RISK OF BURNS, FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS:
- Unplug from the outlet before putting on or taking off parts.
- Close supervision is necessary when this furnishing is used by or near children or individuals with certain disabilities.
- Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.
- Never operate this furnishing if it has a damaged cord or plug if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water. Return the mirror to a Service Center for examination and repair.
- Keep the cord away from heated surfaces.
- Never drop or insert any object into any opening.
- Do not use outdoors.
- Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
- To disconnect, turn all controls to the OFF position, then remove the plug from the outlet.
- Do not leave the appliance unattended when it is plugged in.
- Be sure the mirror is not in a position where it can reflect sunlight; reflected sunlight can cause a fire.
- Do not use on a soft surface, such as a bed, where openings may be blocked.
- Never operate the furnishing with the air openings blocked. Keep the air openings free of lint, hair, and the like.
- Turn the switch to the OFF position, allow the unit to cool, and unplug the cord before replacing lightbulbs.
- Do not place or store this furnishing where it can fall or be pulled into a tub or sink.
- If this furnishing falls into water, unplug it immediately. Do not reach into the water.
- To protect against electrical hazards, do not use it while bathing or in the shower.
- Never use while sleeping.
- Do not use a bulb greater than 6.5 watts.
- Use on any 120 volts 60 hertz AC electric outlet (ordinary house current). Do not use it on any other electrical outlet.
- This appliance is not a toy. Keep away from children
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
To reduce the risk of electric shock, this mirror has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Never use an extension cord unless the plug can be fully inserted. Do not change the plug in any way.
- Your lighted makeup mirror will adjust to different angles. Simply tilt the mirror housing back and place the metal brace in the desired slot on the bar.
- Insert the plug into any standard wall outlet (120 volt AC).
- To turn on the light, simply press the power button on the side of the mirror and then push the mode switch button on the front of the mirror for the desired light setting.
- After use, switch the power button off, unplug and store the mirror in a safe location.
SPECIAL FEATURES
This lighted makeup mirror uses lifetime, energy-saving LED bulbs that do not need to be replaced.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, FULLY INSERT.
CAUTION: RISK OF FIRE, USE ONLY 6.5 WATTS MAXIMUM 120 VOLT, TYPE T BULBS.
DISCONNECT FROM THE SUPPLY CIRCUIT BEFORE SERVICING OR CLEANING. DO NOT
SUBMERGE. MODEL: BE200 RATING: 120V AC 60Hz 0.12A 6.5W
GET TO KNOW YOUR LIGHTED MAKEUP MIRROR
FEDERAL COMMUNICATIONS COMMISSION NOTICE
WARNING: Changes or modifications to this unit that are not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment. This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SUPPLIER’S DECLARATION OF CONFORMITY
Brand: CONAIR® Model No.: BE200 Description: Lighted Mirror Responsible Party:
Conair Corporation, 1 Cummings Point Road, Stamford, CT 06902
203-351-9000 Standards: FCC Part 15
Subpart B, ANSI C63.4-2014 This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation. DATE OF
ISSUE: 11/10/2020
MAINTENANCE
Your lighted mirror is designed for household use and is virtually maintenance-free. No lubrication is needed. If cleaning becomes necessary, disconnect the appliance from the power source and wipe the exterior with a damp cloth. Clean mirror surfaces with a glass cleaner. If any abnormal condition occurs, unplug the lighted mirror, allow it to cool, and return it to an authorized service representative for repair.
SAFETY WARNINGS
If the mirror is not in use, disconnect from the electrical BE SURE DIRECT SUNLIGHT WILL NOT outlet. STRIKE MIRROR WHEN LEFT UNATTENDED; reflected sunlight may cause a fire. Allow it to cool to room temperature before storing. Place in a cool, dry area, out of reach of children, and where it will not be damaged. Handle the cord carefully for longer life. Do not jerk or strain at plug connections or wrap the cord around the mirror for storage. This could cause the cord to become a damaged and short circuit. To store mirror, coil cord loosely and place in large loops next to mirror or secure cord with a twist tie.
WARNING: IF YOU THINK THE POWER IS OFF WHEN THE SWITCH IS OFF, YOU’RE WRONG.
KEEP AWAY FROM WATER
Everyone knows that electricity and water are a dangerous combination. But did you know that an electric appliance is still electrically live even if the switch is off? If the plug is in, the power is on. So when you are not using your appliances, keep them unplugged.
ALWAYS UNPLUG SMALL APPLIANCES
LIMITED ONE-YEAR WARRANTY (U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your unit free if the of charge for 12 months from the date of purchase the appliance is defective in workmanship or materials.
To obtain service under this warranty, return the defective product to the service center listed below, together with – your purchase receipt. California residents need an only pro to vide proof of purchase and should call 1-800-3-CONAIR for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 12 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED
TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12-MONTH DURATION
Some states OF THIS WRITTEN, LIMITED WARRANTY. do not allow limitations on how
long an implied warranty lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, Some states do EXPRESS OR IMPLIED, WHATSOEVER. not allow the exclusion or limitation of special, incidental, or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
Please register this product at
www.conair.com/registration
product, call 1-800-3-CONAIR For info on any Conair
or visit us on the web at www.conair.com
Service Center
Conair Corporation
Service Department
7475 North Glen Harbor Blvd.
Glendale, AZ 85307
©2021 Conair Corporation
20PM075326
IB-16998
Documents / Resources
|
CONAIR BE200 Reflection Mirror LED Lighted
Mirror
[pdf] Instruction Manual
BE200, Reflection Mirror LED Lighted Mirror
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>