joy-it SBC-SSR01 Solid State Relays User Manual
- June 6, 2024
- JOY-It
Table of Contents
joy-it SBC-SSR01 Solid State Relays User Manual
SBC-SSR01
1. GENERAL INFORMATION
Dear costumer, thank you very much for choosing our product.
In following, we will introduce you to what to observe while starting up and
using this product.
Should you encounter any unexpected problems during use, please do not
hesitate to contact us.
Caution!
This product may only be installed by a qualified electrician for your own
safety! Working on electric devices/ systems implies hazard of strokes which
may cause serious injuries or even death!
2. SETUP WITH THE RASPBERRY PI
Wiring:
Caution!
The relays can only handle loads from 100 V to 240 V AC and maximum 2 A.
This product may only be installed by a qualified electrician for your own
safety! Working on electric devices/ systems implies hazard of strokes which
may cause serious injuries or even death!
Code example:
If the signal pin is set to high, the output is enabled.
In the following code example, all output are enabled every 10 seconds for 5
seconds.
3. SETUP WITH THE ARDUINO
Wiring:
Caution!
The relays can only handle loads from 100 V to 240 V AC and maximum 2 A.
This product may only be installed by a qualified electrician for your own
safety! Working on electric devices/ systems implies hazard of strokes which
may cause serious injuries or even death!
Code example:
If the signal pin is set to high, the output is enabled.
In the following code example, all outputs are enabled every 10 seconds for 5
seconds. Before uploading, make sure that you have set the correct board and
port in your Arduino IDE.
4. ADDITIONAL INFORMATION
Our information and take-back obligations according to the Electrical and Electronic Equipment Act (ElektroG)
Symbol on electrical and electronic equipment:
This crossed-out dustbin means that electrical and electronic appliances do not belong in the household waste. You must return the old appliances to a collection point. Before handing over waste batteries and accumulators that are not en-closed by waste equipment must be separated from it.
Return options:
As an end user, you can return your old device (which essentially fulfils the same function as the new device purchased from us) free of charge for dis- posal when you purchase a new device. Small appliances with no external dimensions greater than 25 cm can be disposed of in normal household quantities independently of the purchase of a new appliance.
Possibility of return at our company location during opening hours:
Simac Electronics GmbH, Pascalstr. 8, D-47506 Neukirchen-Vluyn, Germany
Possibility of return in your area:
We will send you a parcel stamp with which you can return the device to us free of charge. Please contact us by e-mail at Service@joy- it.net or by telephone.
Information on packaging:
If you do not have suitable packaging material or do not wish to use your own, please contact us and we will send you suitable packaging.
5. SUPPORT
If there are still any issues pending or problems arising after your purchase,
we will support you by e-mail, telephone and with our ticket support system.
E-Mail: service@joy-it.net Ticket system:
http://support.joy-it.net Telephone: +49 (0)2845 98469-66 (10-17
o‘clock)
For further information please visit our website:
www.joy-it.net
Simac Electronics Handel GmbH
Pascalstr. 8 47506 Neukirchen-Vluyn
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>