iiglo IIFL1280LMW Work Light Installation Guide
- June 6, 2024
- iiglo
Table of Contents
iiglo IIFL1280LMW Work Light Installation Guide
IMPORTANT
- Recharge the work light every 3 months if it is not being used for a long time, or recharge it after used.
- Charge before use, although the battery is delivered in a charged state.
- It is advisable to use the unit from time to time in order to maintain the unit in good condition.
- Do not dispose of the unit into fire or dismantle it under any condition.
- Reverse charging is not acceptable.
- Do not short circuit the battery. Permanent damage to the battery may result.
- Never insert any foreign metallic objects into the charge jack of the work light.
- Never leave the unit in extremely high temperatures while charging.
- Use battery in extreme condition may affect the service life, such as extreme temperature, deep cycle, and extreme overcharged or over discharged.
- Battery should be stored in a cool and dry place.
- Be sure to use manufacturer’s replacement parts.
OPERATION
LOW > HIGH > OFF
[Press OFF if stays at any mode over 10 seconds] [Adjust the stand position
for suitable lighting projection]
BATTERY POWER INDICATION
The LED indicators show battery power after work light is being turned on. When the battery power is low, please recharge the work light as soon as possible.
Charging Status Indicators
Battery Power Indicators
HOW TO RECHARGE
When the work light becomes noticeably dim, switch off the unit and recharge the work light as soon as possible.
- Battery Type: Built-in 2 x 3.7V 2000mAh 18650 Li-ion Rechargeable Batteries
- Charging Time: 6hrs
[Work light turns to about 5% brightness automatically when it is in charging status (with power connected)]
- Open charge jack cover.
- Connect the work light to your PC, or an approved USB adaptor, a solar panel, a portable power bank or any other charging device with an USB outlet, with the micro USB cable plugging to the input port.
- The LED indicators will light up & flash one by one gradually to indicate the battery capacity is being charged.
NOTE
- Recharge the work light every 3 months if it is not being used for a long time, or recharge it after used.
- The rechargeable battery will reach full performance only after a few complete charging & discharging cycles.
- DO NOT leave the work light in charging status (with power connected) continuously for more than five days, as this may cause a reduction in battery efficacy
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>