POOL BLASTER PRO900 Cordless Commercial Pool Cleaner Instruction Manual

POOL BLASTER® PRO 900/PRO 1500 Cordless Cordless Vacuum Operator’s Manual

READ AND SAVE THESE INSTRUCTIONS

WARNING: Read carefully and understand all safety warnings before operating. Failure to do so may result in serious personal injury.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

WARNINGS AND USAGE INFORMATION

WARNINGS

1. Read carefully and understand all safety warnings before using this appliance.

2. Do not attempt to operate if the cleaner or charger appear to be damaged in any way.

3. All cautions and warnings on the equipment should be noted.

4. Never allow children to operate this product. This is NOT a toy, children should be supervised to ensure they do not play with this product.

5. Keep the cleaner and its accessories out of reach of children.

6. Keep proper footing and balance at all times when using the cleaner. Do not overreach.

7. Charge indoor only. Do not use or store the charger outdoors. Charge your cleaner in a clean, dry place and only with the charger provided. Do not use a charger supplied with any other appliance.

8. This cleaner is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

9. The warnings, cautions, and instruction discussed in this instruction manual cannot cover all possible conditions or situations that could occur. It must be understood, the operator should always exercise intensive caution and common sense when utilizing the cleaner.

10. Do not plug or unplug charger into a power source or the appliance with wet hands.

11. Do not operate this cleaner in the presence of flammable or combustible liquids.

12. Never service the cleaner while the unit is on or connected to the charger.

13. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.

14. Use only the charger supplied with the cleaner. Never carry the charger by its cord or disconnect it from an outlet by pulling on the cord.

15. For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily accessible.

16. Risk of electric shock. Do not expose to liquid, vapor or rain. Store cleaner in a clean dry place. Do not store in direct sunlight or expose to extreme temperatures.

17. Please disconnect this equipment from AC outlet before cleaning. Don’t use liquid or sprayed detergent for cleaning. Use moisture sheet or cloth for cleaning.

18. This cleaner contains rechargeable batteries. Do not incinerate the battery as it will explode at high temperatures. Always dispose of batteries in accordance with local law.

19. Leaks from a battery may occur under extreme conditions. If battery liquid gets on the skin, wash immediately with water. If it gets in your eyes, immediately flush your eyes with a mild solution of baking soda and water, and seek medical attention.

20. Keep hair, loose fitting clothing and all body parts away from openings and moving parts of this cleaner.
    USAGE INFORMATION

21. Use this product only for its intended purpose as described in this manual. Use only Water Tech accessories and filters.

22. If the equipment is not use for long time, disconnect the equipment from mains to avoid being damaged by transient over-voltage.

23. Never leave your cleaner in water when it is “OFF” or when it has run out of power.

24. Do not use your cleaner for pool openings; the cleaner is designed for routine maintenance of your pool or spa.

25. The cleaner is designed for underwater use in swimming pools or spas only. It is not an all purpose vacuum cleaner.

26. Submerge the cleaner in water immediately after turning the unit “ON” to prevent damage to the seal on the motor shaft. Failure to do so will shorten the life of the water seal and / or void the warranty.

27. Avoid picking up sharp objects as they may damage the filter. Keep all openings on the cleaner free of debris which may reduce water flow.

28. Do not place the cleaner or charger on or near hot surfaces.

29. For best results use the charger in locations where temperatures are between 50˚ F / 10˚C and 100˚ F / 37.7˚ C.

30. For connection to a supply not in the U.S.A., use an attachment plug adapter of the proper configuration for the power outlet.

DANGER!

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, CAREFULLY FOLLOW THESE INSTRUCTIONS. When using electrical products, read, understand and follow all the instructions stated in this manual.

WARNING!

DROWNING HAZARD. This device produces suction. Risk of entrapment present. DO NOT use when bathers are present. Never permit children to use this product. Never permit persons who cannot swim to use this product to prevent the chance of drowning.

DANGER!

DO NOT ALLOW WATER OR OTHER HIGHLY CONDUCTIVE FLUIDS TO CONTACT THE CHARGER OR CHARGING JACK PRIOR TO OR WHILE CHARGING THE APPLIANCE. Pool water is highly corrosive and will cause damage to the charger or charging jack and can cause short-circuit resulting in smoke fire and/or serious personal injury. Make sure all surfaces of the charger and charging jack are dry and no water is present before charging the appliance.

WARNING!

RECHARGE ONLY WITH A CHARGER MANUFACTURED BY WATER TECH CERTIFIED FOR USE WITH THIS PRODUCT. A charger suitable for one type of battery pack may create a risk of fire when used with another battery pack. DO NOT use an extension cord or power strip. Use only charger certified by Water Tech: LC099 -3S6W-US-EU.

WARNING!

USE ONLY LITHIUM-ION BATTERY supplied by Original Equipment Manufacturer.
Part No. LB003S2P-C.
Different types of batteries or new and used batteries are not to be mixed.

WARNING!

BATTERIES ARE TO BE INSERTED WITH CORRECT POLARITY. DO NOT SHORT-CIRCUIT SUPPLY TERMINALS.

WARNING!

Exhausted batteries are to be removed from the appliance and safely disposed of. If the appliance is to be stored unused for a long period, the batteries should be removed.

Safety and Usage Symbols

Industry Canada Regulatory Information
CAN ICES-3 (B)/NMB-3 (B)

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation, If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

• Reorient or relocated the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different than that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

NOTE: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

1. Vacuum Head (Brushes)
2. Brushes
3. Wheels
4. Vacuum Head
5. Universal Vacuum Head Adapter
6. Nose Cap
7. Multi Layer Filter Bag
8. Pool Blaster PRO Shell
9. Charger and EU Adapter
10. Spring Clip
11. Battery Pack
12. Motor Box Assembly
13. Sand and Silt Bag
14. All Purpose Filter Bag
15. Shoulder Strap

Charging Your Cleaner

Initial Charge 4 Hours
Recharging (After Complete Discharge) 4 Hours
Maximum charging time should not exceed 24 Hours

When fully charged, light will blink green for 1 second every 30 seconds.

Adding the Brushes

Filter Assembly

Attaching the Vacuum Head

(Figure D.1 PRO900)

(Figure D.2 PRO1500)

Brushes

• Brushes are added to the vacuum head. (Figure B)
• Different configurations are available. (6 Brushes Total)

Attaching the Pool Pole

Turning the Cleaner On and Of

Maintenance

Long Term Storage

• Remove the Battery Pack from the charger before storage.
• Always clean the Nose Cap and Filter Bag before storing.
• Always store and charge your cleaner in a cool, dry indoor shelter.
• Recharge the cleaner for 4 hours after each month of inactivity.
• Never leave your charger connected to the cleaner for more than 24 hours.
• Exhausted batteries are to be removed from the appliance and safely disposed of.
• If the appliance is to be stored unused for a long period, the
• batteries should be removed.

Cleaning the Filter Bag

• You should remove and clean the Filter Bag following each use. (Figure G.1)

• Don’t scrub the bag against itself while rinsing it. (Figure G.2)

Only use the battery charger supplied with the cleaner.

Specifications

Battery Charger Input: 100-240V-50-60Hz, 400mA Maximum
Battery Charger Output: 12.6V, 1.A
Water Temperature Range: Maximum 96°F, (35°C) Minimum 40°F, (5°C)
Operation Depth: Maximum 12 ft. (3.5 m), Minimum 10 in. (0.25 m)
Charge temperature: Maximum 100°F, (37.7°C) Minimum 50°F, (10°C)

ADDITIONAL PARTS AVAILABLE:
Head and Hose Attachment (part No.: P30X882)

Car Charger (part No.: LC099-3SW-CR)
Clamp for Motor Box (part No.: P40X031)

To purchase, contact your retailer or call us at (732)-967-9888.

Environmental Program(s), WEEE European Directive

Please respect the European Union regulations and help to protect the environment.
Return non-working electrical equipment to a facility appointed by your municipality that properly recycles electrical and electronic equipment. Do not dispose them in unsorted waste bins. For items containing removable batteries, remove batteries before disposing of the product.

Environmental Recycling Programs USA

Frequently Asked Questions

Q: Can my cleaner be run out of water?
A: Yes, for a short period of time when you turn it on before submerging into your pool or spa.

Q: When I am cleaning my pool how do I know when the cleaner is out of battery power?
A: Most people can feel the cleaner is running through vibration in the vacuum pole or handle. To be sure, you can lift it out of the water to hear if it is running or not.

Q: How often should I clean out my cleaner’s filter bag?
A: You can clean your filter bag as often as you like with no ill effects. The filter bag can then be turned inside out and rinsed with a hose or in a sink. Do not wash it in a washing machine or with detergent. For more detailed instructions, see “Cleaning Your Cleaner” instructions in this manual. For best results, do this after each use, or whenever you notice the performance of your cleaner declining.

Q: Is it normal for me to hear air escaping out of the cleaner when I open the Motor Box Cap?
A: Yes, the powerful motors heat the air in the motor box, which then expands, creating the air sound.

Q: How can I stop dirt from coming out of the nozzle when I take the cleaner out of the water?
A: There are two ways to remove the unit from the pool when done cleaning:
WHEN USING HANDLE: Lift from pool with the nose facing up to allow the water to escape from the back and sides.
WHEN USING A VACUUM POLE: Remove the unit from the pool with the bottom facing upwards and the handle facing down. This will allow the water to escape and keep the dirt inside.

Q: What if I put the cleaner in the pool without the Motor Box Cap in place?
A: Do not operate your cleaner if water gets inside the machine. Drain all unit from the cleaner. Do not use for at least 24 hours. To avoid serious injury or damage, do not replace the Motor Box Cap or attempt to charge or operate your cleaner until it is completely dry.

Q: Can I leave my cleaner’s battery pack on the charger all the time?
A: After charging is complete, the Battery Pack and charger should be removed from the outlet. This will prevent overcharging and prolong the life of your battery pack. IMPORTANT: Disconnect the charger before storing your cleaner.

Q: Where can I buy replacement parts?
A: Look for original Water Tech replacement parts at your local retailer or call 1-732-967-9888 for more details.

Q: Will my pool chemicals hurt the cleaner?
A: This cleaner is designed to withstand pool chemicals during its usage period. However, it should be rinsed off with fresh water after it is removed from the pool. This will increase the life of the filter bag/seal ring.

Q: Can I leave the cleaner in the pool when not in use?
A: No. The cleaner should be removed from the pool and stored in a clean, dry place when not in use. This will increase the life of your cleaner and its accessories.

Q: What do I do if my cleaner does not vacuum?
A: Make sure your cleaner is completely submerged in the water and the air is out of the clear funnel. The cleaner is only designed to vacuum water and will not vacuum air. If that does not resolve your situation please check the following:

• Make sure the filter bag is clear of debris that may be obstructing the flow.
• Make sure the Motor Box Cap has been installed correctly.
• Charge your cleaner for at least 4 hours.

If none of the above help resolve the situation, please call our Customer Service Division at 1-732-967-9888.

END OF LIFE BATTERY DISPOSAL

The maintenance free, Lithium Ion battery in your Pool Blaster must be properly disposed of in accordance to State and local law. To confirm if recycling is required; contact your local authority for information.

WARNING!

• Never attempt to disassemble a battery pack.

1. Remove all personal items such as rings, bracelets, necklaces and watches when unwiring a pack from the vacuum unit.
2. A battery can produce a short circuit current high enough to weld a ring (or like item) to metal causing a severe burn.
3. Wear complete eye protection, gloves and protective clothing when removing the battery pack.
4. Take care not to touch wires together or allow them to contact any metal items, which would cause sparking and/or short circuit the battery.
5. Never smoke or allow a spark or flame in the vicinity of the battery or the cleaner. Batteries can generate gases which could possibly ignite.
6. Do not expose to fire or intense heat as this may result in an explosion.

CAUTION!

• If a battery leak develops, avoid contact with the leaking acid and place the damaged battery in a plastic bag.

7. If acid comes in contact with skin and clothing, wash immediately with plenty of soap and water.
8. If acid comes in contact with eyes, immediately flood eye with running cool water for at least 15 minutes. Get medical attention immediately.

How to remove the battery

• Recommended tools (not included): Philips screwdriver, wire-cutters, electrical tape.

1. Grab the battery and place it as shown. See first image.
2. Using a Philips screwdriver, separate the shells by unscrewing the screws on top of the battery. See second image.
3. Separate the shells and take the battery out. Use the wire-cutters, cut the wires near the battery. Do not cut both wires at the same time. See third image.
4. Finally wrap the wire ends with electrical tape. See fourth image.

10 Alvin Ct., Suite 111
East Brunswick, NJ 08816 – USA
Tel: 732-967-9888 US, Canada & International
Fax: 732-967-0070 US & International
www.WaterTechCorp.com

Register atwww.watertechcorp.com/register

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>