hama 00044307 Lypsi SE 5/6 SAT-Multishalter Instruction Manual
- June 6, 2024
- Hama
Table of Contents
SAT-Multischalter
5/6 NT „Lypsi SE”
SATmulti switch 5/6 NT
00044307
Operating Instructions
SATmulti switch 5/6 NT „Lypsi SE“
Safety instructions
Before opening the device, disconnect the main plug and remove the power
supply; failure to do so could result in serious injury or death. This also
applies when cleaning the device or working on the connections. The device is
not protected against drops or splashes of water. Do not let the product come
into contact with rain, moisture, or other liquids to avoid damaging the
device and to prevent injuries due to short circuits. Only connect the device
to a mains socket that has been approved for the device. The main socket must
always be easily accessible. Never use or open a defective device. Repair work
may only be conducted by an authorized specialist. As with all electronic
devices, keep the device out of the reach of children.
Installation notes:
Only connect the device to a mains socket that has been approved for the
device. Plan out the installation location for the device such that the main
plug can be easily reached and unplugged in case of emergency. Choose an
installation location such that children cannot play with the device r its
connections unsupervised. The installation location must allow for safe
routing of all connected cables. Neither the power supply cable nor the supply
cable may be damaged or crushed by any objects. In order to avoid damage to
the device and any secondary damage, all devices intended for wall-mounting
may only be mounted on a flat surface.
Moisture
Choose an installation location where the device will not, under any
circumstances, come into contact with liquids or other objects (e.g.
condensation, ceiling leaks, water from plants, etc.).
Heat
Do not place the device near heat sources (e.g. radiators, other electric
devices, fireplaces, etc.) and avoid placing it in direct sunlight. Open
flames (e.g. candles) are not to be placed on the device. With devices that
have coolers or ventilation openings, it is very important to ensure that
these are never covered or obstructed. Also, ensure that the device receives
generous air circulation. This will prevent possible damage to the device as
well as fire hazards as a result of overheating. It is also very important to
ensure that the cable does not come into contact with heat sources (e.g.
radiators, other electric devices, fireplaces, etc.).
Hama GmbH &CoKG
86652 Monheim /Germany
www.hama.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>