Laney R210 Bass Guitar Cabinet Instruction Manual

www.laney.co.uk
R210

The R210 Bass Enclosure features high-quality drivers, rugged cabinet construction, tough vinyl covering, protective metal corners and easy-lift handles to deal with the rigours of life on the road!

In addition to this, audio is hooked up via quality Input and Link Speakon connectors located on the rear input plate which also features an On/Off switch for the onboard HF horn. The R210 can be used in both landscape & portrait modes.

Your Bass cabinet should give you years of trouble-free service, however, please take time to read this manual, as it will allow you to get the best from your system.

• 200W RMS/400W Program

• 16-ohm impedance

• 2 x Speakon connectors

• 2 x10” custom-designed drivers

• HF Horn

• Sensitivity: 98dB/W @ 1M

• Frequency Range 50Hz – 4KHz
  50Hz -20KHz with Horn

• Black metal corners, comfortable grip top handle

• Dual Rear Ports

• HWD/mm: 438x579x403

• Weight: 16.0Kg

GENERAL INSTRUCTIONS

In order to take full advantage of your new product and enjoy long and trouble-free performance, please read this owner’s manual carefully, and keep it in a safe place for future reference.

1. Unpacking: On unpacking your product please check carefully for any signs of damage that may have occurred whilst in transit from the Laney factory to your dealer. In the unlikely event that there has been damage, please re-pack your unit in its original carton and consult your dealer. We strongly advise you to keep your original transit carton, since in the unlikely event that your unit should develop a fault, you will be able to return it to you dealer for rectification securely packed.
2. Amplifier Connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your system. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc, BEFORE turing on your bass amplifier. Many products have large transient surges at turn on and off which can cause damage to your speakers. By turning on your bass amplifier LAST and making sure its level control is set to a minimum, any transients from other equipment should not reach your loud speakers. Wait till all system parts have stabillised, usually a couple of seconds. Similarly when turning off your system always turn down the level controls on your bass amplifier and then turn off its power before turning off other equipment
3. Cables: Never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle the amplifier load and could cause damage to your complete system.
4. Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.

British Engineering from the
Black Country United Kindom

IMPORTANT SAFETY INSTRUCTIONS

1. Read Instructions carefully before installing or operating this product.
2. Retain these Instructions.
3. Comply with Warnings: All warnings and instructions for these products should be adhered to.
4. Caution: These professional loudspeaker systems are capable of generating very high sound pressure levels. Use care with placement and operation to avoid excessive levels that can cause permanent hearing damage.
5. Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S. Government’s Occupational Safety and Health Administration (OSHA) has specified the permissible noise level exposure in the chart opposite. According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Ear plugs or protectors in the ear canals or over the ears must be worn when operating this amplification system in order to prevent a permanent hearing loss if exposure exceeds the limits set forth opposite. To ensure against potentially dangerous exposure to high sound pressure levels it is recommended that all persons exposed to equipment capable of producing high sound pressure levels such as this amplification system be protected by hearing protectors while this unit is in operation.

Duration Per Day in Hours
8
6
4
3
2
1 ½
1
½
¼ or less

| Sound Level dBA, slow response
90
92
95
97
100
102
105
110
115
---|---

This product conforms to the requirements of the following European Regulations, Directives & Rules:
CE Mark (93/68/EEC), Low Voltage (2014/35/EU), EMC (2014/30/EU), RoHS (EU2011/65/EU)
——————————————-

In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal household waste to landfill sites. It must be taken to an approved recycling centre according to the recommendations of the WEEE (Waste Electrical and Electronic Equipment) directive applicable in your country.
——————————————
In the interest of continued development, Laney reserves the right to amend product specification without prior notification.
Speakon is a trademark of Neutrik®AG.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>