HMW32 High Bay Microwave Motion Sensor Instruction Manual
- June 16, 2024
- HMW
Table of Contents
HMW32 High Bay Microwave Motion Sensor Instruction Manual
Installation and Instruction Manual
HIGH BAY MICROWAVE MOTION SENSOR
HMW32
Technical Specifications
Installation
Warnings:
- Installation of the sensor involves connecting it to the mains supply. This work must be carried out by a specialist in accordance with electrotechnical regulations.
- Disconnect supply before installing.
A. Ceiling mount
B. Screw to the Luminaire by conduit
C. Attach to the shade by clamp
Rotary Switch Settings
A rotary switch is built inside the sensor for scene selection / fast programming. Total 16 channels available :
Note: settings can also be changed by remote control HRC-11. The last action controls.
Functions
Daylight Harvest (Daylight Regulating)
Daylight sensor measures the available surrounding natural light, calculates how much electrical light is needed to reach the total lux expected. The demand is given to the LED driver by 1-10V signal, so as to deliver the needed amount of electric light.
Note: by pressing the “Sensor off” button on the remote control, the sensor occupancy function is disabled. The target lux level for daylight harvest function can be adjusted by “Brightness +/-” buttons.
Lux Off Function
The built-in daylight sensor can read ambient natural light and switch off the fixture automatically whenever artificial light is unneeded (natural light lux level exceeds daylight threshold). Note: if the stand-by time is preset at “+∞”, the fixture never switches off even when natural light is sufficient.
Ambient Daylight Threshold
Switch the power supply to the sensor two times within 2 seconds, the ambient lux level is sampled and set as the new daylight threshold. Both the settings on rotary switch and the ambient lux level sampled can overwrite each other. This feature enables the daylight sensor to be commissioned to the environment in which it is installed. The last adjustment remains in memory.
8H Manual ON Mode For LED Lamp
Turn off/on the power supply three times within 3 seconds, the light will be turned on for 8 hours, even there is no motion detected, then go back to sensor mode automatically. Note: this 8H manual on mode can be cancelled by turning off/on the power supply one time within 1 second.
Wiring Diagram
Detection Pattern
- For single person walking across, the detection range is reduced by 1/3.
Trouble Shooting
Description of the Button Functions (remote control HRC-11)
WWW.HYTRONIK.COM
Subject to change without notice.
HMW32-20230809-A3
Documents / Resources
| HMW
HMW32 High Bay Microwave Motion
Sensor
[pdf] Instruction Manual
HMW32 High Bay Microwave Motion Sensor, HMW32, High Bay Microwave Motion
Sensor, Microwave Motion Sensor, Motion Sensor, Sensor
---|---