BVSLWU Custos BVS Ball Valve Servo User Manual
- June 6, 2024
- CUSTOS
Table of Contents
BVSLWU Custos BVS Ball Valve Servo
Thank you for choosing our products.
Custos provide whole solution to prevent water damage.
product information
- Utility/insurance driven vertical market
- LoRaWAN Class-C compliant
- Act as Actuator & sensor device
- Nationwide deployment capable
- Smart battery box “Optional accessory”
- Outdoor power adapter
- 10-year warranty
- IP66 waterproof rating
What’s in the box
The Custos BVS snaps over the existing water main valve and will
automatically stop the water supply when a leak is detected.
The Remote Sensor connects to either the Valve Controller
or any Leak Detector to monitor hard to reach areas for leaks.
The Power Supply is a standard 12V power supply, and it is
required to power up the Valve Controller.
Understanding the Custos BVS
Set-up Instructions
-
Close your valve
Valve should open/close easily by hand, without the use of any tools.
The valve handle should be perpendicular to the pipe, which means the valve is closed. -
Align the fork with the valve handle
-
Push down the Custos BVS onto your valve
-
Tighten clamps while holding the Custos BVS down
-
Check if the Custos BVS is facing the right direction
-
Check if the Fork is aligned with the valve handle correctly
-
Plug the Remote Sensor Probe into the Custos BVS
-
Connect the power supply to the Custos BVS and plug it into an outlet
Contact us if you have any questions
Website: http://www.ubitech.hk/
E-mail: info@ubitech.hk
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for Mobile device:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>