VERIDIAN HEALTHCARE 08-363 2-Second Digital Thermometer Instruction Manual
- June 6, 2024
- VERIDIAN HEALTHCARE
Table of Contents
- PLEASE READ AND SAVE THESE INSTRUCTIONS
- NORMAL BODY TEMPERATURE / FEVER INDICATOR
- CHANGING MODES – FAHRENHEIT OR CELSIUS OPERATION
- MEMORY RECALL
- OPERATING INSTRUCTIONS
- ORAL MEASUREMENTS
- AXILLARY (UNDERARM) MEASUREMENTS
- RECTAL MEASUREMENTS
- REPLACING THE BATTERY
- PROBE COVER USE
- CARE AND CLEANING INSTRUCTIONS
- TROUBLESHOOTING / IDENTIFYING DISPLAY SYMBOLS
- PRODUCT SPECIFICATIONS
- FCC STATEMENT
- ONE-YEAR WARRANTY
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
2-Second Digital Thermometer
Model 08-363
THANK YOU FOR PURCHASING A 2-SECOND THERMOMETER. PLEASE READ THESE INSTRUCTIONS CAREFULLY TO ENSURE PROPER USE AND SAFE OPERATION OF YOUR THERMOMETER.
PLEASE READ AND SAVE THESE INSTRUCTIONS
- This product is not intended to diagnose or treat any health problem or disease and should not be used as a substitute for the consultation and advice of a physician or other medical professional.
- Thermometers should only be used under the supervision of an adult.
- Before use, it is recommended that the patient avoid eating, drinking, smoking, or exercising for at least twenty minutes prior to taking a measurement. Never walk, run or talk during measurement.
- If the thermometer has been stored at a very low or high temperature, allow the unit to adjust to room temperature before use.
- Wai a minimum of 1 minute between measurements to allow the unit to readjust to room temperature.
NOTE: Measurement time may vary based on measuring conditions.
NORMAL BODY TEMPERATURE / FEVER INDICATOR
Body temperature can vary from 97°F and 100.0°F and still be considered
normal. The medically accepted ‘normal’ body temperature is 98.6°F Body
temperature is commonly lower upon waking than at any point during the rest of
an individual’s waking hours.
Temperature readings will vary based on the body location point of the
reading. Average ‘normal’ temperature ranges by measurement location site:
Oral 97.0°F–100.0°F (36.1°C–37.8°C)
Rectal 97.3°F–100.4°F (36.3°C–38.0°C)
Axillary 95.4°F–99.0°F (35.2°C–37.2°C)
This thermometer measures the heat flow rate from the user’s body. If the heat
flow for a given measurement location is within normal range, the thermometer
backlight will be green; if the heat flow rate is high, the backlight will be
red, indicating a fever MAY be present.
A fever is defined as a body temperature that is elevated above the normal for
that person. It is important to determine what is normal for an individual
before determining if a fever is present. Tracking an individual’s temperature
on a consistent basis, at the same body site, and at the same time, every day
when the person is well or healthy will help determine an individual’s normal
temperature.
CHANGING MODES – FAHRENHEIT OR CELSIUS OPERATION
This unit defaults to a Fahrenheit measurement when first used and will
default to the last used mode each time the unit is turned on.
To change modes (the device should be OFF
- Press and hold the MODE and POWER buttons simultaneously.
- The current scale mode will briefly show on the display and then alternate to the new model.
- The thermometer is now ready for measurement; either proceed with measurement or press the POWER button to turn the unit off.
MEMORY RECALL
This unit includes a recall of the last measurement taken. When the unit is OFF, press the POWER button to turn the unit on, and release it. After the self-test, the unit will briefly show the last reading on the display.
OPERATING INSTRUCTIONS
Remove the LCD protective sticker. Press and release the POWER button to activate the thermometer. The unit will beep and the display will show all of the digital display symbols as it performs a self-test before showing the last reading in memory. The thermometer will then show the current mode; press the mode button to select the desired measurement location.
The thermometer will default to Oral the first time it is turned; the
thermometer will default to the last mode used for all other uses.
NOTE: If using a probe cover, apply before turning the device on.
ORAL MEASUREMENTS
- Place the probe under the tongue as near as possible to a heat pocket as noted in the diagram. Readings will progressively lower the further the probe is from the indicated heat pockets.
- Hold the thermometer in place during the reading; do not bite down on the thermometer. The mouth must remain closed to ensure accurate results. The reading should take approximately two seconds.
- The measurement will start automatically once the probe is in place and will take approximately 2 seconds. A running circle will briefly appear on the display indicating the reading is in progress.
- The unit will sound one long beep when the measurement is complete and the reading will appear on the display.
- Wait a minimum of one minute before attempting a new measurement.
- To turn the unit off, simply press the POWER button. The unit will automatically shut off after approximately one minute.
AXILLARY (UNDERARM) MEASUREMENTS
- Wipe the underarm with a dry towel before application.
- Place the probe tip under the arm so that the tip is touching skin; hold the thermometer parallel, slightly angled upwards as indicated in the diagram. Position the arm across the chest to ensure the tip is completely covered. The reading should take approximately two seconds.
- The measurement will start automatically once the probe is in place and will take approximately 2 seconds. A running circle will briefly appear on the display indicating the reading is in progress.
- The unit will sound one long beep when the measurement is complete and the reading will appear on the display.
- Wait a minimum of one minute before attempting a new measurement.
- To turn the unit off, simply press the POWER button. The unit will automatically shut off after approximately one minute
RECTAL MEASUREMENTS
- It is recommended that a probe cover is used for rectal measurements; apply a water-soluble lubricant for easier insertion.
- Lay the patient on their side or stomach with their legs hanging down.
- Gently insert the tip of the probe NO MORE THAN .5 INCH into the rectum. Stop immediately if you detect resistance. Always hold the thermometer in place during measurement.
- Hold the thermometer in place during the reading; the reading should take approximately two seconds.
- The measurement will start automatically once the probe is in place and will take approximately 2 seconds. A running circle will briefly appear on the display indicating the reading is in progress.
- The unit will sound one long beep when the measurement is complete and the reading will appear on the display.
- Wait a minimum of one minute before attempting a new measurement.
- To turn the unit off, simply press the POWER button. The unit will automatically shut off after approximately one minute.
REPLACING THE BATTERY
This thermometer includes 1 2032Li 3V coin battery. If the battery is low, the
battery symbol will appear on the display and flash; replace the battery as
soon as possible.
If the battery symbol appears solid, the battery is expired and must be
replaced for the unit to operate.
- Ensure the power is off and carefully slide the battery cap away from the unit.
- Remove the expired battery and replace it with a new battery with the plus (+) side up.
- Carefully replace the battery cap.
- Do not dispose of used batteries in the trash. Consult your local recycling center for the proper way to dispose of batteries in your area. Keep used batteries away from children, pets, and excessive heat.
PROBE COVER USE
Disposable, hygienic probe covers are recommended for use with stick thermometers to prevent contamination. Probe covers are intended for one-time use only; a new probe cover should be used with each application. Probe covers can commonly be found at your local retailer.
CARE AND CLEANING INSTRUCTIONS
Store the unit in the provided protective case when not in use. Do not store
the thermometer where it will be
exposed to direct sunlight, dust, or humidity. Avoid extreme temperatures. Do
not attempt to disassemble the unit. If ERR displays and no measurement can
be obtained, the unit must be replaced.
Clean the thermometer by wiping with rubbing alcohol (70% isopropyl alcohol)
or soap and water. Do not submerge in any liquid or autoclave; this
thermometer is NOT waterproof or shockproof. Wipe the thermometer with a dry
cloth and allow it to air dry.
TROUBLESHOOTING / IDENTIFYING DISPLAY SYMBOLS
Performance may be degraded should one or more of the following occur:
- Operation outside stated temperature and humidity range
- Storage outside state temperature and humidity range
- Mechanical shock
The thermometer has been designed to display feedback warnings to ensure proper usage and accurate temperature measurement. In the event of a malfunction or incorrect temperature measurement, the following warnings will be displayed:
Error | Problem/Cause | Solution |
---|---|---|
The measured temperature is above 107.6°F (42°C) | 1. Turn the unit OFF and |
then ON again
2. Retake temperature
3. If still reads HI, this indicates that the patient has a high fever; seek
medical attention
| The measured temperature is below 95°F (35°C)| 1. Turn the unit OFF and
then ON again
2. Retake temperature
3. If still reads LO, this indicates that the patient has a low body
temperature; seek medical attention
| The thermometer is too cold or too hot to operate| 1. Verify that the room
temperature within product range 60.8°F-104°F (16°C – 40° 0
2. Retake temperature
| The temperature did not register
because of poor contact, patient movement, or poor placement| Turn the unit
OFF, wait 2 minutes, turn it ON again and retake the temperature
| Unit malfunctioned| Do not use the thermometer — contact Customer Care
| Low battery- Battery icon flashes| The battery is low; enough power remains
for approximately 10 measurements
| Drained battery – The battery icon is the only icon on the display and the
unit turns off| The battery is completely expired and must be replaced
PRODUCT SPECIFICATIONS
MEASUREMENT TIME: 2 seconds
MEASUREMENT SITE: Oral, Rectal, Axillary
MEASUREMENT RANGE: 95.0°F – 107.6°F (35° – 42°C)
OPERATING TEMPERATURE: 60.8°F – 104.0°F (16°C – 40°C); Humidity 15-95% (non
condensing)
STORAGE TEMPERATURE: -4.0°F – 122.0°F (-20°C – 50°C); Humidity 15-95% (non
condensing)
MEASUREMENT SCALE: Fahrenheit and Celsius
MEMORY: Recall of the last measurement taken
BATTERY: 1 2032Li 3V battery
BATTERY LIFE: Approximately 24 months; minimum of 1000 measurements
AUTOMATIC SHUT-OFF: Approximately after 1 minute of non-use
ACCURACY: complies with ASTM E 1112-00 standards
DISPLAY: Liquid crystal display
DISPLAY RESOLUTION: LCD 0.63” x 0.73”
DIMENSIONS: 5.15” X 1.1” X .6”
WEIGHT: .5 ounces with batteries
FCC STATEMENT
IMPORTANT INFORMATION REQUIRED BY THE FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference; and (2) this device must accept any interference received,
including interference that may cause undesirable operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
ONE-YEAR WARRANTY
Congratulations on your purchase of a 2-Second Digital Thermometer. Your
Thermometer is covered by the following limited warranty commencing upon the
date of purchase, and subject to the following terms and conditions: The
Warrantor warrants that its Thermometer will be free from defects in materials
and workmanship under normal consumer usage for a period of one year for the
original purchaser of the Thermometer.
Periodic maintenance, repair, and replacement of parts due to normal wear and
tear are excluded from coverage. Defects or damage that result from: (a)
improper operation, storage, misuse or abuse, accident or neglect, such as
physical damage (cracks, scratches, etc.) to the surface of the product
resulting from misuse; (b) contact with liquid, water, rain, extreme humidity
or heavy perspiration, sand, dirt or the like, extreme heat, or food; (c) use
of the Thermometer for commercial purposes or subjecting the Thermometer to
abnormal usage or conditions; or (d) other acts which are not the fault of the
Warrantor, are excluded from coverage. This warranty does not cover batteries
or other power sources that may be provided with or used with the Thermometer.
If the Digital Thermometer fails to conform to this limited warranty, return
the Thermometer to Attn: Repair Department, 1175 Lakeside Drive, Gurnee, IL,
60031. When returning a product, please also include: (i) a copy of your
receipt, bill of sale, or other comparable proof of purchase; (ii) a written
description of the problem; and (iii) your name, address, and telephone
number. Carefully package the product to avoid any damage that may occur while
in transit; shipping insurance with returned receipt is recommended. At our
option, the warrantor will repair or replace the unit found to be defective in
materials or workmanship under normal consumer usage. The purchaser will be
notified of any additional repairs required prior to completing the repair and
will be responsible for parts charges if any, and repair charges not covered
by this limited warranty.
EXCEPT AS PROVIDED FOR IN THIS LIMITED WARRANTY, ALL EXPRESS AND IMPLIED
WARRANTIES AND CONDITIONS ARE DISCLAIMED, INCLUDING WITHOUT LIMITATION THE
IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
THE REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS LIMITED WARRANTY IS THE
EXCLUSIVE REMEDY OF THE CONSUMER AND IS PROVIDED IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED. IN NO EVENT SHALL THE WARRANTOR BE LIABLE,
WHETHER IN CONTRACT OR TORT (INCLUDING NEGLIGENCE) FOR DAMAGES IN EXCESS OF
THE PURCHASE PRICE OF THE PRODUCT, OR FOR ANY INDIRECT, INCIDENTAL, SPECIAL OR
CONSEQUENTIAL DAMAGES OF ANY KIND, OR FOR DAMAGES TO, OR LOSS OF, OTHER
PROPERTY OR EQUIPMENT OR PERSONAL INJURIES TO THE FULL EXTENT THESE DAMAGES
MAY BE DISCLAIMED BY LAW.
Some states and jurisdictions do not allow the limitation or exclusion of
incidental or consequential damages, or limitation on the length of an implied
warranty, so the above limitations or exclusions may not apply to you. This
warranty gives you specific legal rights, and you may also have other rights
that vary from state to state or from one jurisdiction to another.
Toll-Free Customer Care Help Line:
1-866-326-1313
Monday – Friday 8:30 a.m. – 4:30 p.m. CST
www.veridianhealthcare.com
Distributed by: Product of Israel
Veridian Healthcare Packed in China
1175 Lakeside Drive #93-1242 06/20
Gurnee, IL 60031 ©2020 Veridian Healthcare, LLC
www.veridianhealthcare.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>