EHX Micro Q-Tron Envelope Controlled Filter User Guide

June 6, 2024
EHX

EHX nano log

EHX Micro Q-Tron Envelope Controlled Filter

EHX Micro Q-Tron Envelope Controlled Filter featured

Congratulations on your purchase of the Micro Q-Tron envelope controlled filter! The Micro Q-Tron is identical to our Mini Q-Tron but in a compact pedal. The envelope controlled filter is a unique type of sound modifier in which the user’s playing style controls the effect. The volume of the input signal (also called the envelope) controls the cutoff frequency or center frequency of a swept filter. As your instrument’s volume increases or decreases, so does the pitch of the filter.

CONTROLS

DRIVE CONTROL
This is the filter sweep sensitivity control. Turning the DRIVE control clockwise will cause the filter to react more to your playing. The more you turn up the DRIVE control, the higher in frequency the filter will jump when you play a note. When first plugging into the Micro Q-Tron, start with this control at 12 o’clock.
Q CONTROL
Determines the peak bandwidth of the filter. As the Q control is turned clockwise, the filter will sound increasingly narrow with a more obvious peak, making the effect more dramatic. Start with Q set to about 2 o’clock.
MODE ROTARY SWITCH (LP BP HP)
Determines what frequency range the filter will pass. Emphasizes lows in LP mode (Low Pass), midrange in BP mode (Band Pass) and highs in HP mode (High Pass).
STATUS LED
When the LED is lit, the Micro Q-Tron is in effect mode. When the LED is off, the Micro Q-Tron is True Bypass mode.
FOOTSWITCH
Toggles the Micro Q-Tron between effect and True Bypass modes.
CONNECTIONS
Connect your instrument to the INPUT Jack. Connect your amplifier to the AMP Jack.

POWER

POWER
Power, from the internal 9-volt battery or external battery eliminator, is activated by plugging into the Input jack. The input cable should be removed when- the unit is not in use to avoid running down the battery. The barrel connector on the front of the Micro Q-Tron is for a 9-volt battery eliminator capable of delivering 100 mA of current. The inner ring of the 9-volt battery eliminator must be negative, the outer ring positive. The unit’s battery may be left in or taken out when the eliminator is in use.

BATTERY
The Micro Q-Tron can run off of a 9V battery. To change the 9-volt battery, you must remove the 4 screws on the bottom of the Micro Q-Tron. Once the screws are removed, you can take off the bottom plate and change the battery. Please do not touch the circuit board while the bottom plate is off or you risk damaging a component.

PLAYING THE MICRO Q-TRON

The Micro Q
Tron’s effect is controlled by the musician’s playing dynamics: a stronger attack or louder note will yield a more dramatic effect, while softer playing will produce more subtle effects. Use the full range of control settings in combination with different playing techniques to obtain a number of different and unique effects combinations. You might find that the DRIVE and Q controls work best when they are in the middle of their range rather than maximized.
When you play a note into the Micro Q-Tron, its filter will jump up to a high frequency and then slowly descend in frequency according to the envelope of the notes you play. The louder your note, the higher in frequency the filter jumps.

WARRANTY INFORMATION

Please register online at http://www.ehx.com/product-registration or complete and return the enclosed warranty card within 10 days of purchase. Electro-Harmonix will repair or replace, at its discretion, a product that fails to operate due to defects in materials or workmanship for a period of one year from date of purchase. This applies only to original purchasers who have bought their product from an authorized Electro-Harmonix retailer. Repaired or replaced units will then be warranted for the unexpired portion of the original warranty term.

If you should need to return your unit for service within the warranty period, please contact the appropriate office listed below. Customers outside the regions listed below, please contact EHX Customer Service for information on warranty repairs at info@ehx.com or +1-718-937-8300. USA and Canadian customers: please obtain a Return Authorization Number (RA#) from EHX Customer Service before returning your product. Include with your returned unit: a written description of the problem as well as your name, address, telephone number, e-mail address, and RA#; and a copy of your receipt clearly showing the purchase date.

United States & Canada
EHX CUSTOMER SERVICE
ELECTRO-HARMONIX
c/o NEW SENSOR CORP.
47-50 33RD STREET
LONG ISLAND CITY, NY 11101
Tel: 718-937-8300
Email: info@ehx.com

Europe
JOHN WILLIAMS
ELECTRO-HARMONIX UK
13 CWMDONKIN TERRACE
SWANSEA SA2 0RQ
UNITED KINGDOM
Tel: +44 179 247 3258
Email: electroharmonixuk@virginmedia.com

This warranty gives a purchaser specific legal rights. A purchaser may have even greater rights depending upon the laws of the jurisdiction within which the product was purchased.
To hear demos on all EHX pedals visit us on the web at www.ehx.com
Email us at info@ehx.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals