babylo Grande XL Stroller Instruction Manual

Grande
XL Stroller
Instruction Manual

IMPORTANT: RETAIN FOR FUTURE REFERENCE READ CAREFULLY

Parts List

Safety

CAUTION:
TO AVOID INJURY OR DEATH
Read these instructions carefully before use and keep them for future reference. The child may be hurt if you do not follow these instructions.
WARNING! Follow the manufacturer’s instructions.
WARNING! Always apply the brakes whenever the pram/stroller is stationary.
WARNING! Do not leave the child unattended.
WARNING! Secure the child in the harness at all times.
WARNING! Do not carry extra children or bags on this pram/ stroller.
WARNING! Make sure children are clear of any moving pans if you adjust the warn, stroller. Otherwise, they may be injured.
WARNING! Use the harness at all times.
WARNING! Use the tether strap to stop the pram/stroller from rolling away.
WARNING! Check that the pram body or seat unit attachment devices are correctly engaged before use.
WARNING! The product is not suitable for running or skating.

Remember, your child’s safety is your responsibility:

• Always fit and use the tether strap when the stroller is in use.
• When using the stroller, always ensure your hand is positioned in and around the tether strap. The strap is a compulsory safety feature that must be used at all times. It is for the safety and benefit of your child.
• This product is suitable for one child in an upright or reclined position from birth and up to 15kg.
• The stroller will become unstable if the manufacturer’s recommended load is exceeded.
• The correct use and maintenance of this stroller are essential.
• Be sure that all clamps and buckles are securely fixed and in place before use
• When in the stroller, your child must always wear the safety harness, correctly fitted and adjusted, at all times.
• Always use the harness correctly fitted and adjusted, with your child in the
• Never leave the harness buckles when not fitted to a child in the stroller because the harness can form loops which may pose a strangulation hazard.
• When in use, the head of the child in the product should never be lower than the body of the child.
• Use the stroller on flat or gently sloping surfaces. It may be unstable on higher sloping and uneven surfaces – be aware of the possibility of the stroller tipping over.
• Care should be taken if the stroller is used on stairs or escalators.
• Care must be taken when folding and unfolding the product to prevent finger entrapment.
• Check all parts before use for breakage or fatigue. Discontinue use immediately if any part is found to be damaged or broken.
• The basket can carry a maximum load of 5kg.
• This product is suitable to be used with a newborn baby. Please ensure the seat is in its full recline position when used with a newborn child.
• Do not carry additional children. This stroller is manufactured for use with one child only.
• Any load attached to the handle and/or on the back of the backrest and/or on the sides will affect the stability of the product.
• Always be aware of the risks provided by fire and other significant sources of heat such as radiators etc. which may be in the immediate vicinity of your
• Be aware of the risk of an open fire and other sources of heat, such as electric bar fires, gas fires, etc. in the vicinity of the stroller.
• It may be unsafe to use any accessories other than those approved by
• Keep the plastic packaging away from children to avoid the danger of
• Take extra care in windy conditions.
• Lift and carry the stroller safely. Please ensure all locking devices are engaged before lifting the stroller – injuries can occur from moving parts.
• Only carry stroller if folded and locking or storage latches are engaged.
• Please apply storage latch if the latch does not engage automatically
• Never leave a rain cover, hood, or apron on the product indoors, in a hot atmosphere, or near a heat source, as your child may overheat
• To prevent damage, always remove a rain cover before folding the pram.
• This product is intended for domestic use only. It is not for commercial use.

This product conforms to AS/NZS 2088:2013

Assembly

1. Release the stroller (A) from the locked position by lifting the locking catch from over the locking rivet on the frame. Note. You may have to squeeze the legs and handles together first so as to release the tension on the rivet. Standing behind the stroller and holding it by the handle, lift the handle upwards to unfold the stroller.

2a. Lean the stroller forward and press the rear wheel (C) post into the rear frame hub until it “clicks” into place. Repeat for the other side.
NOTE. Pull-on the rear wheels to ensure that it is securely attached to the stroller.

2b. To remove, push release button and pull wheel from the hub.

3a. Attach the front wheels (B). Insert wheel housing onto the front leg and push upward until you hear it “click” into position. Repeat for another side.

4a. Insert the canopy (E) clips into the slot located on each side of the seat unit and fasten the Velcro fasteners on both sides.

5. Attach the bumper bar (D) by aligning the anchors with the slots on the seat unit. Push until the bumper bar “clicks” into place.
NOTE. The bumper bar must be securely attached before using this product. Press the buttons on both sides to remove the bumper bar.

Backrest Adjustment

Locate the backrest adjustment mechanism at the rear of the seat. Squeeze the clip on the reclining harness and gently lower the backrest. Alternatively, squeeze the clip on the reclining harness and gently pull up the backrest to the desired height.
WARNING! Always ensure that the seat is securely fixed in position before use.

Footrest Adjustment

Press the buttons on both sides of the footrest support to adjust it up or down.

Swivel Wheels

The front wheels are equipped with a swivel locking device. Turn the lock on each wheel down to activate swivel wheels.

Brakes

To engage brakes, apply downward pressure to the brake lever located on the rear axle. Check that the stroller does not move once the brakes are properly applied. To release, gently lift up on the brake lever.
WARNING! Always engage wheel brakes when the stroller is not moving.

Harness

1. Slide the shoulder strap buckle onto the housing of the waist strap buckle. Repeat for the other side.

2. Insert the completed buckle into the buckle housing until it engages securely in place. Listen for the “click”. Repeat for the opposite side.
   

3. Press the center button to release child from harness

4. To adjust the harness, move the slides as shown.
   WARNING! Always adjust the harness to fit your child correctly for their comfort and safety. A loose-fitting harness can be very dangerous.

5. The stroller has 3 shoulder height positions.
   WARNING! Always adjust the shoulder harness length according to baby height.
   To adjust the shoulder height position, feed harness tabs through a slot (a) in the seat unit. Re-insert the harness tabs through slots at the desired height (b). Pull out from front of the seat.

Seat Fabric Removal

1. Unfasten the press studs located on the stroller frame and remove the cover off the hooks.
   

2. Unfasten the middle wedding fastener located under the seat and the strap under the footrest. Remove the seat fabric. To re-install the seat fabric, reverse the above steps.
   

Folding

1. Fold the canopy and apply the brake.
2. Slide the folding button across and push up the safety lock.
3. Push the stroller handle down until the lock engages with a “click”.

Care

Maintenance:
The product requires regular maintenance to ensure correct and safe performance. Regularly inspect the wheels, locks, brakes, harness, catches, seat adjusters, joints, and fixings to ensure they are clean, operating correctly, and in full working order. Replace tires if they are excessively worn. Do not use this product if any part is broken, torn, or missing, and use only spares provided by the manufacturer. If parts become stiff or difficult to operate, ensure dirt is not the cause, then try a light application of a silicone lubricant, ensuring it penetrates between the components. Regular lubrication of moving parts will extend the life of your product and make opening and folding easier. The stroller should be serviced and reconditioned before using for a second baby, or within 18 months, whichever is sooner. After exposure to damp conditions, dry off with a soft cloth and leave fully open in a warm environment. Storing damp will encourage mildew to form. Store in a dry place. Do not leave in sunlight for prolonged periods as some fabrics may fade.

Cleaning:
Spot or sponge clean fabrics with mild detergent. Use mild soap or upholstery shampoo. Wash separately. NEVER use bleach. Dry in shade thoroughly before reuse and avoid direct heat and sunlight. Do not iron. Do not dry clean. Wipe clean plastics and metals with a damp cloth. Never clean any part of the product with abrasive, ammonia-based, bleach-based, or spirit-type cleaners. Ensure the product is fully dry before use or storage. Always ensure the product is stored in a dry place to prevent mold or mildew from developing.

Due to variation in style and design, the illustrations used in this instruction manual are generic. Variation in design may occur in the images shown.

Supplied by Baby Factory NZ. Ltd.
58 Stonedon Drive, East Tamaki, Auckland, New Zealand
www.babyfactory.co.nz
180621

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>