greenworks LME363 Lawn Mower User Manual

LME363 Lawn Mower
User Manual

DESCRIPTION

PURPOSE

This machine is used for domestic lawn mowing. The cutting blade must be approximately parallel to the ground. All four wheels must touch the ground while you mow.

OVERVIEW

Figure 1-9.

1. Quick-release lever
2. Lower handle
3. Upper handle
4. Knob
5. Bolt
6. Grass catcher
7. Rear discharge door
8. Mulch plug
9. Height adjustment lever
10. Battery door| 11. Battery pack
12. Safety key
13. Start button
14. Handle switch
15. Front-wheel
16. Rear-wheel
17. Slot
18. Mounting nut
19. Spacer
20. Blade
---|---

SAFETY

WARNING
Make sure that you follow all safety instructions.
Refer to Safety Manual.

INSTALLATION

WARNING
Do not use accessories that are not recommended by the manufacturer.
WARNING
Do not put in the safety key or the battery pack until you finalised the assembly of all the parts.

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before use.
WARNING

• If parts of the machine are damaged, do not use the machine.
• If you do not have all the parts, do not operate the machine.
• If the parts are damaged or missing, contact the service center.

1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with local regulations.

UNFOLD AND ADJUST THE LOWER HANDLE

Figure 2.

1. Pull up and back the upper handle to lift the handle into operation position. Make sure that the handles click into position correctly.
2. Tighten the lower handle with the quick-release levers on the two sides.

NOTE
Make sure that the two handles are in the same position.
WARNING
Do not make damage to the cables when you fold or unfold the handle.

INSTALL THE UPPER HANDLE

Figure 3.

1. Align the holes in the upper handle and the lower handle.
2. Put the bolts through the holes.
3. Tighten the knobs onto the bolts.
4. Do the same operation on the other side.

INSTALL THE GRASS CATCHER

Figure 4.

1. Remove the mulch plug.
2. Open the rear discharge door and hold it.
3. Hold the grass catcher by its handle and put the hooks over the slots.
4. Close the rear discharge door.

INSTALL THE MULCH PLUG

Figure 5.

1. Remove the grass catcher.
2. Open the rear discharge door and hold it.
3. Hold the mulch plug by its handle and fit it in the discharge chute.
4. Close the rear discharge door.

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
Figure 6.

1. Pull the height adjustment lever rearward to increase the blade height.
2. Pull the height adjustment lever forward to decrease the blade height.

INSTALL THE BATTERY PACK

Figure 7.
WARNING

• If the battery pack or charger is damaged, replace the battery pack or the charger.
• Stop the machine and wait until the engine stops before you install or remove the battery pack.
• Read, know, and follow the instructions in the battery and charger manual.

1. Open the battery door.
2. Align the lift ribs on the battery pack with the grooves in the battery compartment.
3. Push the battery pack into the battery compartment until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.

NOTE

The engine starts only when you put in the safety key.

REMOVE THE BATTERY PACK

Figure 7.

1. Open the battery door.
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.

OPERATION

WARNING
Wear eye protection during operation.

START THE MACHINE

Figure 8.

1. Put in the safety key.
2. Push and hold the start button.
3. While you hold the start button, pull the handle switch in the direction of the handlebar.
4. Release the start button to start the machine.

STOP THE MACHINE

Figure 8.

1. Release the handle switch to stop the machine.

WARNING
Wait until the blades fully stop before you start the machine again. Do not quickly turn the machine off and on.
WARNING
Always remove the safety key and battery pack after you complete the work.

EMPTY THE GRASS CATCHER

1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it from the slots.
6. Close the rear discharge door.
7. Empty the grass catcher.

OPERATE ON SLOPES

WARNING
Do not mow on the slopes with an incline of more than 15°. If you are not comfortable, do not mow on a slope.

• Do not go up and down on a slope, mow across the face of the slope. Be careful when you change the direction on a slope.
• Monitor the holes, ruts, rocks, and other hidden objects that can cause you to fall. Remove all obstacles such as rocks and tree limbs.
• Make sure that your footing is stable. If you are out of balance, release the handle switch immediately.
• Do not mow near drop-offs, ditches, or embankments.

OPERATION TIPS

• Do not try to override the operation of the start button or bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick grass.
• Clean the bottom of the mower deck after each use.
  Remove grass clippings, leaves, dirt, and other debris.

MAINTENANCE

WARNING
Remove the safety key and battery pack from the machine before maintenance.
WARNING
Keep the engine and battery pack free from grass, leaves or too much grease.
CAUTION
Use only approved replacement parts.
CAUTION
Do not let brake fluids, gasoline, petroleum-based materials touch the plastic parts. Chemicals can cause damage to the plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic housing or components.

GENERAL MAINTENANCE

• Before each use, examine the machine for damaged, missing, or loose parts such as screws, nuts, bolts, and caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use water.

REPLACE THE BLADE

Figure 9.
WARNING
Use only approved replacement blades.
WARNING
Wear heavy gloves or wind cloth around the blade when you touch the blade.

1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the blade.
6. Remove the mounting nut and spacer with a wrench or socket.
7. Remove the blade.
8. Install the new blade. Make sure that the raised points engage the hole(s) in the blade.
9. Put in the mounting nut and spacer and tighten them.

STORE THE MACHINE

• Remove the safety key.

• Remove the battery pack(s).

• Clean the machine before storage.

• Make sure the motor is not hot when you store the machine.

• Make sure that the machine does not have loose or damaged parts. If it is necessary, follow these instructions:
  • Replace the damaged parts.
  • Tighten the bolts.
  • Speak to a person at an approved service center.

• Store the machine in a dry area.

• Make sure that children cannot come near the machine.

TROUBLESHOOTING

the height of the handle and make sure that the knobs and bolts are aligned correctly.
The machine does not start.| The battery capacity is low.| Charge the battery pack.
The handle switch is defective.| Replace the handle switch.
The safety key is not put in.| Put in the safety key.
The machine cuts grass unevenly.| The lawn is rough.| Examine the mowing area.
The blade height is not set correctly.| Adjust the blade/ cutting height to a higher position.
Problem| Possible cause| Solution
---|---|---
The machine does not mulch correctly.| Wet grass clippings attach to the deck.| Wait until the grass dries before mowing.
The mulch plug is missing.| Install the mulch plug.
The machine is hard to push.| The grass is too tall, or the blade height is too low.| Increase the blade/ cutting height.
The grass catcher and the blade
drags in thick
grass.| Empty the grass clippings from the grass catcher.
There is a high vibration in the machine.| The blade is unbalanced and worn.| Replace the blade.
The motor shaft is bent.| I. Stop the motor.
2. Remove the safety key and battery pack.
3. Inspect for damage.
4. Repair the machine before you start it again.
The machine stops during mowing.| The blade height is too low.| Increase the blade/ cutting height.
The battery pack is out of power.| Charge the battery pack.
The grass clippings attach to the deck or the blade.| Remove the battery pack and check the deck.
The operation temperature of the machine is too high.| Cool the machine.

• If you cannot find the solution to these problems, go to the service center.

TECHNICAL DATA

WARRANTY

(The full warranty terms and conditions can be found on the Greenworks webpage)
The Greenworks warranty is 3 years on the product and 2 years on batteries (consumer/private usage) from the date of purchase. This warranty covers manufacturing faults. A faulty product under warranty might be either repaired or replaced. A unit that has been misused or used in other ways than described in the owner’s manual might be rejected for warranty. Normal wear, and wear parts are not considered a warranty. The original manufacturer warranty is not affected by any additional warranty offered by a dealer or retailer.
A faulty product must be returned to the point of purchase in order to claim for warranty, together with the proof of purchase (receipt).

EC DECLARATION OF CONFORMITY

Name and address of the manufacturer:
Name: GLOBGRO AB
Globe Group Europe
Address: Riggaregatan 53, 211 13 Malmö, Sweden

Name and address of the person authorized to compile the technical file:
Name: Peter Söderström
Address: Riggaregatan 53, 211 13 Malmö, Sweden

Herewith we declare that the product
Category: Lawn Mower
Model: LME363 (2513907)
Serial number: See product rating label
Year of Construction: See product rating label

• is in conformity with the relevant provisions of the Machinery Directive 2006/42/EC.
• is in conformity with the provisions of the following other EC-Directives:
  • 2014/30/EU
  • 2000/14/EC & 2005/88/EC
  • 2011/65/EU & (EU)2015/863

Furthermore, we declare that the following parts, clauses of harmonized standards have been used:

• EN 60335-1, EN 60335-2-77, EN 62233, EN ISO 3744,
  EN 55014-1, EN 55014-2, ISO 11094, IEC 62321-3-1,
  IEC 62321-4, IEC 62321-5, IEC 62321-6, IEC
  62321-7-1, IEC 62321-7-2. IEC 62321-8

Conformity assessment method to Annex VI Directive 2000/14/EC.

Measured sound power level LWA: 87.2 dB(A)
Guaranteed sound power level LWA.d : 96 dB(A)

Place, date: Malmö,03.03.2020
Signature: Ted Qu, Quality Director

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>