VOLT VFL-451X-ABZ 10W Integrated LED Flood Light with Yoke Mount Installation Guide
- June 6, 2024
- VOLT
Table of Contents
VOLT VFL-451X-ABZ 10W Integrated LED Flood Light with Yoke Mount
Installation Guide
Important: Please Read Before Installation
This luminaire is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.
These instructions do not intend to cover all variations in installation, operation maintenance or mounting situation.
- Make sure that the power is turned OFF before installing or servicing this luminaire.
- WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or more from pool, spa or fountain.
- This luminaire is intended to be used only with a power supply (transformer) rated maximum of 300 watts (25 AMPS) at 12V AC.
- Wiring connections must be made with wire connectors that are suitable for outdoor use.
- Position the low voltage wire and wire connector so that it is located within 6 inches (15.2 cm) from a building structure, a luminaire or fitting.
- The main low voltage cable is intended for shallow burial – less than 6 inches (152 mm).
Important Safety Instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS.
- Turn off/unplug and allow to cool before replacing lamp.
- Lamp gets HOT quickly! Contact only switch/plug when turning on.
- Do not touch the hot lens, guard or enclosure.
- Keep lamp away from materials that may burn.
- Do not touch lamp at any time. Use a soft cloth. Oil from skin may damage lamp.
- Do not operate the luminaire fitting with a missing or damaged shield.
Package Contents
A. (1) Fixture body
Parts Required
A. (1) Mounting Accessory
B. (1) Coupler
C. (1) Hex Nut
Product Dimensions
INSTALLATION INSTRUCTIONS
Install Stake
Determine the desired location for mounting the stake. Hammer the stake into the ground until flange of stake is flush to grade. To avoid damage to the stake, place a board on top of the stake while hammering.
Note: If the ground is hard and the stake is difficult to install, make a crosscut in the ground using a flat shovel.
Install Fixture Body to Stake
Thread the coupler onto the stake. Place the yoke mount of the fixture body over the coupler and secure with the hex nut. Hand tighten until snug.
Wire Connections
Strip both leads from the fixture wires. Using two UL listed wire connectors (sold separately), connect the leads from the fixture wires to the main supply cable leads.
Adjust Fixture Body Direction
Adjust the fixture body to the desired orientation and tighten the screws with the wrench.
After installation:
A. Check to make sure the fixture is mounted properly.
B. Check to make sure the wires are connected properly.
Last, turn on the power and check if the lighting fixture works. If not, turn off the power and contact your local electrician.
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-
Sun 10am – 6pm (EST)
Specifications and product details subject to change without notice.
© Copyright 2021, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
customersupport@voltlighting.com •
813.978.3700
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>