LOWRANCE Elite FS 9 Inch Fishing System Installation Guide
- June 6, 2024
- LOWRANCE
Table of Contents
Elite FS 9 Inch Fishing System
Installation Guide
Parts included
A Elite FS™unit
B Gimbal bracket kit
C Sun cover
D Power cable kit
Compliance statements
Declarations
The relevant declarations of conformity are available at:
www.lowrance.com
Europe
Navico declares under our sole responsibility that the product conforms with
the requirements of:
- CE under RED 2014/53/EU
United States of America
Navico declares under our sole responsibility that the product conforms with
the requirements of:
- Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
! Warning: The user is cautioned that any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that of the receiver is connected
- Consult the dealer or an experienced technician for help
ISED Canada
This device complies with ISED (Innovation, Science and Economic Development)
Canada’s license-exempt RSSs.
Operation is subject to the following two conditions: (1) This device may not
cause interference; and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Australia and New Zealand
Navico declares under our sole responsibility that the product conforms with
the requirements of:
- level 2 devices of the Radiocommunications (Electromagnetic Compatibility) standard 2017
- radiocommunications (Short Range Devices) Standards
Trademarks
®Reg. U.S. Pat. & Tm. Off, and ™ common law marks. Visit www.navico.com /intellectual-property to review the global trademark rights and accreditations for Navico Holding AS and other entities.
Wiring
Note: The illustration shows connection examples. Accessories and
additional devices are sold separately.
A Power, 10 pin-connector
B NMEA 2000®, Micro-C connector
C Ethernet, 5-pin connector
D Sonar, 9-pin connector
Power (A)
The unit is designed to be powered by 12 V DC.
It is protected against reverse polarity, under-voltage, and over-voltage (for
a limited duration).
A fuse or circuit breaker shall be fitted to the positive supply.
| Wire color | Purpose |
|---|---|
| Red | + 12 V |
| Black | DC negative |
NMEA 2000® (B)
The NMEA 2000® data port allows receiving and sharing of a multitude of data
from various sources.
Ethernet (C)
Ethernet is used to interconnect high bandwidth devices such as radar, sonar
modules, and other displays.
Connection of network devices can be made directly to the Ethernet port, or
via a network expansion device.
Sonar (D)
Note: A 7-pin transducer cable can be connected to a 9-pin port using a
7-pin to 9-pin adapter cable. However, if the transducer has a paddlewheel
speed sensor, the water-speed data will not be displayed on the unit.
Supports:
- Sonar / CHIRP Sonar
- DownScan
- SideScan
- ActiveImaging™/ActiveImaging™ 3-in-1/TotalScan®/StructureScan®
- LiveSight™ via PSI-1
Note: ActiveTarget™ transducers are supported via its external module connected to the Ethernet network.
Gimbal Bracket Mounting
Dimensional drawings
7” unit
9” unit
Technical specification
| 7”| 9”
---|---|---
Environmental| |
Operating temperature range| -15°C to +55″C (5″F to 131T)
Storage temperature| -20°C to +60°C (4°F to 140°F)
Waterproof rating| IPX6 and IPX7
Electrical| |
Supply voltage| 12VDC (10 – 17 VDC min-max)
Fuse rating| 3 A
Power consumption (maximum)| 28W (2 A at 13.8 V DC)
Display| |
Resolution| 800 x 480 pixels
Viewing angles in degrees| 50° top, 60° bottom
70° left and right
Brightness| > 1200 nits
Touch screen| Multitouch
Physical| |
Weight (display only)| 0.9 kg (1.9 lbs.)| 1.2 kg 12.7 lbs.)
Compass Safe Distance| 0.5 m (1.6 ft.)
Interface/Connectivity|
NMEA 2000^| I port (Micro-C connector)
Data card reader| lx slot (microSD. SDXC)
Ethernet| I port
IS-pin Ethernet connector, 100Base-TI
Sonar| 1 port
(9-pin connector)
WWI Internal| 802.11b/g/n
Bluetooth®| 4.0 with support for Bluetooth® Classic
GPS| 10Hz high-speed update
WARS, MSAS, EGNOS, GLONASS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>