HUGHES PWD30-EPO Bluetooth Surge Protector with Auto Shutoff Instruction Manual
- June 6, 2024
- Hughes
Table of Contents
HUGHES PWD30-EPO Bluetooth Surge Protector with Auto Shutoff
PWD30-EPO SURGE MODULE REPLACEMENT INSTRUCTIONS
Step one:
Loosen and unscrew the top and bottom cable gland connectors.
Step two:
Unscrew the 8 Phillips screws（M3*16) on the back side of the unit.
Step three:
Carefully separate the top and bottom halves of the Power Watchdog
Unit.
Step four:
Unclip the connections. Take note of where these connections come
from.
Step five:
Carefully slide out the used up surge module.
Step six:
Slide in the new surge module into the slots inside the Power Watchdog unit.
clip together the connections.
Note -you may use the white connector only, or you may use the red and
white connectors. Just match the color and size of your connectors.
Step seven:
Place top and bottom halves together, rescrew all the screws, tighten down the
cable gland connectors
Do not overtighten the screws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>