FIAMMA 98655-932 Hymer 290cm Awning Adapter Installation Guide

: June 6, 2024
: FIAMMA

Table of Contents

ATTENTION: INSTALLATION ON FIXING KIT
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

Installation instructions for brackets
ADAPTER HYMER
98655-932 / 98655-933
98655-934 / 98655-935
98655-936 / 98655-937
98655-938
F80s – F65

Check that nothing has been damaged or deformed during transport. In the event of doubts or questions concerning the installation, use or limitations of the product, contact the dealer. We recommend that the installation is carried out by qualiﬁed personnel and in compliance with current local regulations.

ATTENTION: INSTALLATION ON FIXING KIT

The awnings are to be fixed on the brackets so that the words “SUPPORT” on the awning are in correspondence of the brackets: this condition is necessary and indispensable for the two brackets situated at the extremities (which are located on the fixing point of the arms on the case-box). It is important, but not indispensable, for the central bracket/s as it/they provide/s only mounting support.
The brackets must always be well-aligned to each other to avoid later problems; in case they are not, they must be properly shimmed using the spacers to ensure alignment. The installation of the awning can occur only when the brackets are perfectly aligned to the roof of the vehicle.

Important: use of SIKA 252 adhesive is essential for fixing the bracket (brackets).

Attention Security.
Remove this label only after ﬁxing the awning on the adapter.

When using the awning please follow the instructions of the product.
ATTENTION Periodically check the brackets to make sure they are firmly attached (especially after the first kilometers) make sure the bolts are not loose and that holding brackets have not shifted.

Read the following instructions and warnings carefully; failure to observe these installation and usage instructions as well as the laws for driving in the relevant country may cause severe harm or damage for which the manufacturer declines all responsibility. Before installation, ensure compatibility with the vehicle on which the product must be installed. Checking that the wall/roof/rear door is sufﬁ ciently solid and suitable for guaranteeing the resistance of the anchoring points is always mandatory. If not, strength and compliance with the maximum load indicated in the instructions are not guaranteed and it will be necessary to reinforce it these points.

Warranty Fiamma. In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.

https://www.fiamma.it/en/
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)

All rights reserved.
Fiamma S.p.A.
reserves the right to modify at any time, without notice, prices, materials, speciﬁ cations, and models or to cease production of any model.
R0_IS_98690-837_revB

Documents / Resources

| FIAMMA 98655-932 Hymer 290cm Awning Adapter [pdf] Installation Guide
98655-932, 98655-933, 98655-934, 98655-935, 98655-936, 98655-937, 98655-938, Hymer 290cm Awning Adapter
---|---