HPRT QUTIE Mini Portable Label Printer Instructions
- June 6, 2024
- HPRT
Table of Contents
Product Introduction
Ameanance and Components
Packing list
Product Introduction
LED Indicator Status
• Red LEO Error Status;ON: Error (Paper jam/Paper end/Cover opened) Quick
Flash: TPH Is over-temperature Slow Flash: Low power
• Green LED Basic Status; ON: Charging finished/Printer Is ready Slow Flash:
Charging
Button Operation
Hold down the power button for a few seconds: Turn on/off the printer
Press the power button: Position and calibrate the location of thermal label
paper and heating line
Paper Loading
Place your hands on both sides of the side cover, push upward per the
direction shown in the figure to open it.
Load the paper as shown in the figure and make sure the
thermosensitive layer faces up.
Close the side cover and pull some extra paper. 
App Download
Scan the QR code to download App.
Connection and Printing
01 Open App, click “Device Connection”, select “Quote”.
02 Select “Scan to get the template”, then scan the QR code on the paper core
to recharge consumables mileage and get the templates.
03 Edit the label as needed, and then click “Print” after editing.
04 Push the cutter button to manually cut the paper.
Note: App operation shall be subject to the latest version.
Battery Charging
When the battery power is low, the red LED indicator will flash slowly. Please
charge it by the exclusive USB cable in time. If you continue printing, it may
power off automatically.
Note: The printer can be charged via a computer USB port or AC adapter. Please note that the AC adapter is not supplied.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. if
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Manufacturer: Xiamen Hanin Electronic Technology Co., Ltd.
Address: No.96,
Rongyuan Road,
Tongan District,
Xiamen,
China 361100
E-mail: [email protected]
Web: www.hprt.com 