aiwa MI-X300 Frontier Portable Party Speaker User Manual
- June 6, 2024
- Aiwa
Table of Contents
Aiwa MI-X300 Frontier Portable Party Speaker User Manual
AIWA Electronics International Co., Ltd.
Explore more at www.int-aiwa.com
Package Contents
MI-X300 Frontier Portable Party Speaker
USB Type-C Charging Cable
3.5mm Audio Cable
User Manual
Product Diagram
- Power Button
- Led Indicator
- Volume Down /Previous Track Button
- Mic receive
- Play/Pause
- Volume Up/ Next Track Button
- Equalizer/ Sound Effect
- Battery indicator
- Light Mode Button
- Microphone Input
- Reset
- USB Disk reading port
- AUX
- USB Type-C Charging Port
- TF-card Slot
Specifications
Operating Instructions
Charging
- Fully Charge this speaker before first use.
- Use the included USB Type-C charging cable and a 5V 2A power adapter to charge your speaker. The power adapter is NOT INCLUDED.
- When there are 3 solid white lights, your speaker is fully charged and ready for use.
Battery
Power On/Off
Connection Methods
1. Bluetooth Pairing
2. Other Connection Methods
Note:
- If a code or pin is required for pairing, please enter “0000”
- The speaker will automatically shut down after 30 minutes in pairing mode if no devices are paired.
- If speaker can not enter pairing, please reset the speaker to clear the pairing list or any program erros.
- The speaker can remember last volume and mode, it will continue at the same status when turns on again.
- If your paired device is switched off or manually disconnected, the speaker will enter pairing mode and automatically shut down after 30 minutes.
- If the speaker or connected device exceeds the operating range, the speaker will disconnect. The connection to the last successfully connected device will be re-established once you re-enter wireless range within 30 minutes. To connect to other devices, please repeat the previous “Pairing” steps.
Hands-Free Calling
True Wireless Stereo
Note: In “True Wireless Stereo” mode, only the master speaker has phone call function.
Basic Control
Microphone function
(The following situations are all after the microphone is connected)
Product Care & Use
- Keep away from liquids, extreme heat, and strong magnetic fields.
- Do not use this speaker at high volume for extended periods, as this may cause permanent hearing damage or loss.
Federal Communications Commission (FCC) Statement. This device complies with
part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation. Note: This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide Reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications made to this device not expressly approved by SHENZHEN WEIKING TECHNOLOGY CO., LTD may void the FCC authorization to operate this device.Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
RF exposure statement:
The device compliance RF exposure requirement and can installed and used without restriction.