KINGSTAR K010 TWS Wireless Earbuds User Guide
- June 6, 2024
- KINGSTAR
Table of Contents
KINGSTAR K010 TWS Wireless Earbuds User Guide
User Quick Guide
]
KEY DEFINITION
CHARGING MODE
HEADSETS PAIRING MODE
REMARK 1.
Wireless pairing name bobos H-21. 2. When the music is played, place it into the charging box . At the moment, the headsets disconnect from the mobile phone. The headsets switch of( When take the headset out from the charging case, it powers on automatically for connection. 3. Connect the mobile phone automatically after power on. 4. If the headsets can’t connect to the mobile phone, reboot and connect again. 5. Maximum DC 5V,excessive voltage will damage the charging box.
FCC STATEMENT
NOTE: This equipment has been tested and found to comply with the Hmits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These Hmits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
fr&quency energy and, if not installed and used in accordance with the
instructions, may ca.use harmful interference to radio communications.
However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does ca. use harmful interference to radio or television
reception, whicti can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
whist, the receiver is connected.
– Consult the dealer or an experienced radio/TV tedlnician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could vokl the user’s authority to operate “ttle equipment
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment . This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
FCC ID : 2ADOMKS11
Keep All Relevant Information for Future Reference
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>