behringer ULM300USB Ultralink 2.4 GHz handheld Mic + USB Receiver User Guide
- June 6, 2024
- Behringer
Table of Contents
**behringer ULM300USB Ultralink 2.4 GHz handheld Mic + USB Receiver User Guide
**
Hook-up
-
XENYXQX2442USB
-
B115MP3
-
Laptop
Controls
Model: ULM300M
Type of product: Wireless Microphone
- USB connector
- POWER/STATUS LED
- VOLUME UP Button (—Power on/-Volume up/-Unmute)
- VOLUME DOWN Button (-Volume down/—Mute/—Power off from Mute)
NOTE: “—” (long dash) = long press; “-” (hyphen) = short press.
LED Status Key
The following table describes LED behavior on both the microphone and the USB wireless receiver:
Activity
| LED Color|
LED Behavior
---|---|---
No Signal
| Amber|
Flashes on/off slowly
Connected, Active
| Green| Solid
Connected, Muted| Green|
Flashes on/off quickly
Connected, Active,
| Low Battery Green/Red| Alternating colors
Connected, Muted, Low Battery| Green/Red|
Alternating colors, flashes on/off
ULM300USB Getting Started
-
Plug the USB wireless receiver to the designated USB socket on wireless-enabled Behringer mixers, powered speakers or other compatible products, or to a USB port on a computer.
The POWER/STATUS LED on the receiver will slowly flash amber. -
Press and hold the VOLUME UP button on the wireless microphone to switch it on and commence transmission. Both the LEDs on the wireless microphone and USB wireless receiver will light solid green once connected.
-
Once switched on, the wireless microphone will be set at its previous operating volume level.
Use the VOLUME UP and VOLUME DOWN buttons to adjust the volume. -
A long press of the VOLUME DOWN button will put the wireless microphone into mute.
The mute condition is indicated by rapid green flashing of the LED. If the user does not unmute within 10 minutes, the wireless microphone will power down to save battery life. -
A further long press of the VOLUME DOWN button when in mute will switch off the wireless microphone.
-
A short press of the VOLUME UP button will unmute the wireless microphone. When the wireless microphone is unmuted, it will return to the previous volume level.
NOTE: The connection range between speaker and Bluetooth streaming device may decrease if Bluetooth streaming and wireless microphones are used simultaneously.
LEGAL DISCLAIMER
Music Tribe accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Aston Microphones and Coolaudio are trademarks or registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2021 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding Music Tribe’s Limited Warranty, please see complete details online at community.musictribe.com/pages/support#warranty
Specifications
RF output
|
< 10 dBm (10 mW)
---|---
Operating range
| 60 m (200 ft)*
Dynamic range|
93 dB, A-weighted**
Equivalent input noise
| -120 dBu
Frequency response|
10 Hz – 20 kHz, ±1 dB** (wireless link)
Sampling rate
| 48 kHz
Resolution|
24-bit
Encoding
| 4-bit ADPCM (192 kbps)
Latency|
14.3 ms
RF frequency
| 2.4 GHz ISM band (2.404~2.468 GHz, 17 channels)
USB current consumption|
70 mA @ 5 VDC
Battery type
| 2 x AA (LR6) Alkaline cells
Battery life|
24 hrs
Dimensions (H x W x D)
Microphone
| 260 x 53 x 53 mm (10.2 x 2.1 x 2.1″)
Wireless receiver|
8.5 x 76 x 22 mm (0.3 x 3.0 x 0.9″)
Weight
Microphone
| (0.3 kg (0.7 lbs)
Wireless receiver|
0.01 kg (0.02 lbs)
Achievable range will be dependent on nearby sources of RF interference and/or
line of sight obstacles.
Measured from analog input to analog output at maximum level.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
Behringer: ULM300USB
- Responsible Party Name: Music Tribe Commercial NV Inc.
- Address: 122 E. 42nd St.1, 8th Floor NY, NY 10168, United States
- Email Address : legal@musictribe.com
FCC ID: QWHULM300M
ULM300USB
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to
the following
two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by Music Tribe can void the user’s authority to use the equipment.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
Warning
- As with all small batteries, the batteries used with this product should be kept away from small children who still put things in their mouths. If they are swallowed, promptly call your local poison control center.
- Always purchase the correct size and grade of battery most suitable for intended use.
- Replace all batteries of a set at the same time.
- Clean the battery contacts and also those of the device prior to battery installation.
- Ensure the batteries are installed correctly with the regard to polarity (+ and -).
- Always remove battery if consumed or if product is to be left unused for a long time.
- Replacement of a battery with an incorrect type that can defeat a safeguard! Replace only with the same or equivalent type!
- Risk of fire or explosion if the battery is replaced by an incorrect type.
- Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
- Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas; and
- A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas
- Attention should be drawn to the environmental aspects of battery disposal.
Hereby, Music Tribe declares that this product is in compliance with Directive 2014/53/EU, Directive 2014/30/EU, Directive 2014/35/EU, Directive 2011/65/EU and Amendment 2015/863/EU, Directive 2012/19/EU, Regulation 519/2012 REACH SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S
Address: Gammel Strand 44, DK-1202 København K, Denmark
UK Representative: Music Tribe Brands UK Ltd.
Address: 6 Lloyds Avenue, Unit 4CL London EC3N 3AX, United Kingdom
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>