SyncSign D75C 7.5-Inch E-ink Display User Manual
- June 6, 2024
- SyncSign
Table of Contents
7.5-Inch
Syncsign® Display
User Manual
Getting to know Syncsign Display
Packing list
Node-Hub Pairing Mode
Note: The 7.5inch Display connects with the Hub via ZigBee protocol, either you’ve purchased SyncSign loT Hub or this is your first SyncSign order, the Display was paired to the Hub before shipping out from the factory. After the Hub was bound to your SyncSign account, use a pin clip to poke the pin- hole for Is, then release, then the Display will wake up to join the Hub. Then the Hub can push the content to the Display via the ZigBee protocol.
There is a little occasion that requires resetting the Display or unpairing it from the Hub. If you want to reset the Display, please contact SyncSign Support first.
Need Assistance?
| https://help.sync-sign.com | |
|---|---|
| [ help@sync-sign.com ](mailto:help@sync- |
sign.com)
For more:
Search “SyncSign” on social networks
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (I) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Pan 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
NOTE: This device and its antenna(s) must not be co-located or operating
in conjunction with any other antenna or transmitter
RF Exposure Statement
To maintain compliance with FCC’s RF exposure guidelines, This equipment
should be installed and operated with a minimum distance of 20cm the radiator
your body. This device and its antenna(s) must not be co-located or operating
in conjunction with any other antenna or transmitter
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>