TOPFLYtech TLW2-2BL Asset GPS Tracker User Manual
- June 6, 2024
- TOPFLYtech
Table of Contents
TOPFLYtech TLW2-2BL Asset GPS Tracker
TLW2-2BL
The tracker is using GNSS & LTE technologies and could collect device
coordinates then transfer them via LTE network to the server. It provides
customers with cost-effective, efficient, and safe management. It has been
widely used in commercial transportation, company vehicle fleet management,
intelligent transportation, logistics, car rental, engineering machinery,
marine transportation, and other segments.
Quick Reference
FOTA (firmware over the air) Notification
TOPFLYtech is committed to providing clients with the best user experience. We
are offering an automatic firmware update feature for every device. This
feature allows devices to always have the latest version of firmware. It can
save clients the time and effort of updating firmware manually. Please note
that this feature is enabled in default. If you want to turn it off, please
contact with TOPFLYtech. If this feature is disabled, the fw update only can
be done by sending the upgrade command manually.
Product Specifications
Network Specifications
Frequency Range
| ****
BLE: 2402-2480MHz(1M/2M)
Data Transmission| ****
NB1: Max. 32Kbps (DL), Max. 70Kbps (UL) NB2: Max. 127 (DL), Max. 158.5 (UL)
EDGE: Max. 296Kbps (DL), Max. 236.8Kbps (UL) GPRS: Max. 107Kbps (DL), Max. 85.6Kbps (UL)
GNSS Specifications
GNSS Chipset| MediaTek High Gain GNSS receiver
Parallel GNSS| GPS+Glonass or GPS+Beidou
---|---
Receiver type:| 33 tracking / 99 acquisitions- channel GNSS receiver
Sensitivity| Acquisition: -149 dBm
Tracking: -167 dBm
Reacquisition: -161 dBm
Horizontal Position Accuracy| Autonomous: < 2.5 m CEP
TTFF @ -130 dBm with (without) EASY™| Cold Start: < 15s (32s) Warm Start: < 8s
(28s) Hot Start: < 1s (1s)
Interfaces
Network, GNSS Antenna| Internal only
Indicator LED| Network and GNSS
FOTA| Yes
Temperature Sensor| 1 temperature sensor
BLE 5.0| Yes
Tracker Configuring| Micro USB connector
General Specifications
Waterproof| IP65
Dimensions| 120mm42mm12mm (4.72” 1.65” 0.47”)
Weight| 49g (1.73oz)
Battery| Li-Polymer 200 mAh/ 3.7V
Operating Voltage| 7V to 60V DC
Operating Temperature| -25℃ ~ +70℃ (-13°F ~ 158°F)
Storage Temperature| -40℃ ~ +85℃ (-40°F ~ 185°F)
Air Interface Protocol
Transmit Protocol| TCP, UDP, MQTT, SMS
Protocol Check & Encryption Support| MD5/ AES256
BLE Accessory Support| Yes
Scheduled Timing/angle/distance Report| Report position and status at preset
intervals
External Power Status Alarm| Report when external power is disconnected
Low Power Alarm| Report when backup battery is low
Speeding Alarm| Report when speed exceed the pre-set value
Towing Alarm| From internal 6-axis accelerometer
Remote Control| Remote output control
Network Signal Jamming Detection| Report network jamming
Data Roaming Control| Avoid additional data consumption
Driving Behavior Monitoring| Aggressive driving behavior detection, e.g.,
harsh braking and acceleration
Crash Detection| Accident data collection for reconstruction and analysis
Standard Accessories Introduction
LED indicator and SIM card Slot
Note: Indicator lights will go out automatically after the tracker turns on for 8 mins.
Wire Definition
Installation Guide
SIM Card Pre-Installation Note
SIM card data service should be enabled.
If SIM card is locked via PIN, please unlock it first.
Ensure there is sufficient balance in the SIM card.
SIM card installation
Open the rubber stopper on the side
Insert the SIM card by following the direction icon on the tracker cover
Give a little push to the SIM card. When there is a “click” sound, it stands
for the SIM card has been successfully inserted
Installation
Away from emission sources such as all kinds of sensors, burglar alarm,s and other communication devices.
Quick Trouble Shooting
Unable to Connect to the Tracking Platform
Check the APN and IP settings.
Check the SIM card whether supports a specific network and the data service
whether is enabled.
Make sure there is no limitation or already added server IP to the IP
whitelist when using a M2M SIM card.
Check the remaining balance or network signal of the SIM card.
Tracker Shows Offline
Check the external power voltage to see whether the tracker is disconnected
from external power.
Check whether the vehicle entered the network blind area.
Check the balance of tracker SIM card.
If the connection lost happens on the last several days of the month, check
whether the network service is terminated by carrier because of exceeding the
max data usage volume.
Unable to locate
Is the top side (with TOP SIDE logo on) facing upwards without being shielded
by metallic things during the installation?
Does the vehicle enter an area with no satellite coverage?
Location Drift
In an area with poor GNSS signal (like the areas with lots of high buildings), location drift may happen. When moving to an open area, the drift will no longer exists.
No Command Reply
Check the command format. Make sure it’s correct.
The vehicle may be in-network blind area.
Ensure the SIM card is properly inserted.
Warranty and Stock
The standard warranty period is 12 months starting from the date of purchase.
If the tracker will be stored for a long time, please connect it to the
external power and recharge the internal battery (10 hours) every 3 months. It
will be helpful to the internal battery life.
Optional Accessories List
FCC Warning
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
Caution!
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
IMPORTANT NOTICE:
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator and your body.
ISEDC Warning
This device complies with Innovation, Science, and Economic Development Canada
licence-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
the device is compliance with RF exposure guidelines, users can obtain
Canadian information on RF exposure and compliance.The minimum distance from
body to use the device is 20cm.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>