Jm Manufacturing JMS251-27-1 RC Robot Fighting User Manual
- June 6, 2024
- Jm Manufacturing
Table of Contents
- Jm Manufacturing JMS251-27-1 RC Robot Fighting User Manual
- Regulations for Guardians
- 3, Buttons on controller
- How to play
- 7 How to play Better
- 8 Victory or Defeat (Under fighting mode)
- Auto Drone mode (One player with two robots)
- Situations as below:
- FCC Radiation Exposure Statement:
- NOTE:
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Jm Manufacturing JMS251-27-1 RC Robot Fighting User Manual
Regulations for Guardians
- Don’t disassemble, reform nor repair the product by yourself except charging batteries.
- Indoor use only, Not for outdoor. • Choking Hazard – Small parts, don’t put in mouth.
- To avoid the danger of eating the small parts, please keep this product away from children under 3 years old.
- Don’t tie your fingers with the connecter from controller.
- Don’t use nor store the product in the heat.
- Don’t bend nor pull the spare parts of the product.
- Don’t throw nor drop the product.
- The rechargeable batteries may get hot. damaged or leaked due to misuse.
- Make sure the batteries not to be short-circuited.
- Don’t charge the batteries again soon after a full charge.
- Stop using in case batteries are with water otherwise a short-circuit will be caused.
- Keep the batteries away from water and fire. Don’t disassemble nor weld the batteries.
- Don’t use, charge nor store the batteries in the heat.
- Use rechargeable batteries only for the robot.
- Please follow the instructions of batteries and charger.
- Don’t mix rechargeable batteries with other types.
- Insert the batteries with correct polarity (+ / -). •Switch off the robot and rechargeable batteries should be taken out after using,
- Batteries of the controller may get hot, damaged or leaked due to misuse.
- Use alkaline batteries for the controller.
- Don’t mix new batteries with old ones. Only batteries are of the same or equivalent types as recommended are to be used.
- Insert the batteries with correct polarity (+ -).
- Switch off the controller and batteries should be taken out after using.
- Make sure the batteries not to be short-circuited_ •Stop using in case batteries are with water otherwise a short-circuit will be caused.
- Don’t disassemble nor weld the batteries.
- Keep the batteries away from water and fire. • Don’t use nor store the batteries in the heat.
- In case eyes are splashed with leaked batteries please wash and see a doctor at once. If any on your skin or clothes please wash.
- Mind your fingers. hair or clothes not to be trapped by the wheels of the robot.
- Don’t shake nor hit the product randomly.
- To avoid the danger of suffocation, don’t put the package over head nor face.
3, Buttons on controller
- Buttons on left hand controller control the left foot of the robot.
- Buttons on right hand controller control the right foot of the robot
Distributed by: JM Manufacturing (HK) Ltd. Unit G, 4/F Ka iser Estate, Phase
2,
No. 47-53 Man Yue Street, Hung Hom, Kowloon, Hong Kong Made in Shantou, Cltina
How to play
7 How to play Better
°As illustration on As illustration on As illustration on Unique Skill I .
OAs illustration on QAs illustration on Unique Skill II. right. Press right.
Press right. Press right. Press right. Press
the 2 buttons on controller at the the 2 buttons on controller at the the 3
buttons on controller at the the 3 buttons on controller at the the 4 buttons
on controller at the
same time, same time, same time, same time, same time, you will hear the laugh
of victory. you will hear “Hey come on come on”. the robot fights with its the
robot fights & spins. the robot fights with its
8 Victory or Defeat (Under fighting mode)
How to Win:
Technique Beat the opponent for 5 times on its face. K.O Knock Out the
opponent.
OUT Beat the opponent to be out of the arena.
Press the race of the defeated robot for ::i seconds till you hear the bell to
recover it.
Then the robot will be back and under your control again
TT The recovery will rmt affect the connection be tween tne robot and
controller.
When the robot is attacked, LED lights flash. And the robot will be totally
defeated and stop moving once it is beat for 5 times by the opponent.
Auto Drone mode (One player with two robots)
- Set one of the robots to its Auto Drone Mode. Switch on both robot and controller. Then press the face of the 4 buttons on controller for 2 B’ Then the robot accesses to its Auto Drone Mode. The robot Just fights automa 1ca y.
- Control the other robot to fight with the auto one.
Situations as below:
► The robot is controlled by thecontro ller. When the controller stops
w~rking, the robot:lso st~s.
► When the distance between the two is shortened and the controller 1s
started, the ro at war s.
► The robot slows down, with wrong responds, out of control, ~ncl then stops,
LED lights turn dark.
► The controller doesn’t work properly. Signal interrupts. LED lights tum
dark.
FCC Radiation Exposure Statement:
This device complies with Pan IS of the FCC Rules. Operation is subject to the following two conditions: (I) this device may not cause harmful interference. (2) this device must accept any interference received ,including interference that may cause undesired operation. Warning :Changers or modifications to this unit not expressly approved by the party responsible for the compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Clan II digital device ,pursuant to Past, IS of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates ,uses and can radiate radio frequency energy and ,if not installed and used in accordance with the instructions ,may cause harmful interference to radio communications.
Flossesser, there is no guarantee that interference will not occur in a particular installation .if this equipment dose cause harmful interference to radio or television reception ,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radial TV technician for help.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>