3i PVI1R02 PIVO Remote Control User Guide
- June 6, 2024
- 3i
Table of Contents
Pivo Remote Control Overview
Pairing the Remote Control
-
Press the power button 3 times in quick succession until the LED indicator turns white.
-
Press and hold the “+” button on the Remote Control until you hear 3 quick beeps.
This sound indicates that the pairing is complete.
Replacing the batteries -
Remove the cover
-
Replace the batteries (Coin type, 3V lithium cell)
Battery code: CR1632
Default Settings
+ Capture photo / Start recording
∧ Increase speed
∨ Decrease speed
< Rotate clockwise
> Rotate counterclockwise
< < Rotate clockwise 1 round
> > Rotate counterclockwise 1 round
Stop rotating /Cancel shooting
M Toggle between photo/video mode
- This function may vary depending on the mode. For detailed information on how to use the Remote Control for each mode, visit help.getpivo.com.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, under art 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used following the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.
‐‐Connect the equipment into an outlet on a circuit different from that to which the receiver connected.
‐‐ Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>