maono WM820 Wireless Microphone System User Guide

WM820
Wireless Microphone System
Quickstar Guide

TX & RX

| PAIR


---|---
TX
| RX


|

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following.

Measures

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and
  receiver.

• Connect the equipment into an outlet on a circuit different
  from that to which the.

• receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Key operation and LED lighting instructions

Buttons (Transmitter TX)
Power Button -Press and hold the power button for 2 seconds to turn on/off the unit
Mute Button – Single-click the mute button to mute and unmute.
The LED light will turn red when muted
Pair Button – Press and hold the pair button to pair the transmitter to the receiver

Connector (Transmitter TX)
USB-C Charging Port- 5V, 1A Max
3.5mm Microphone Input – When plugging in an external microphone, the transmitter will automatically switch to the external mic input

LED Indicator (Transmitter TX)
Connection indicator :
Solid – connected ; Flash – disconnected ; Rapid Flash -connecting

• Turn on the power on the transmitter and the LED will flash. Then turn on the power button on the RX receiver, and WM820 will automatically pair the transmitter to the receiver and the LED will remain solid.

Battery LED Indicator ：
No lights = internal battery is above 20%
Red LED flash = internal battery is below 20%
Solid Red LED = charging. Once fully charged, the red light will turn off

Buttons (Receiver RX)
Power Button – Press and hold the power button for 2 seconds to turn on/off the RX (receiver)
Volume+ Rocker **+**– Short press to increase the output volume
Volume – Rocker**-** – Short press to lower the output volume
Pair Button – Press and hold both the volume+and- button for at At least 2 seconds until the LED light on the receiver start to flash

Connector (Receiver RX)
USB-C Charging Port – 5V, 1A Max
OUTPUT – 3.5mm TRS connector
Headphone connector – Plug the transmitter into the headphone jack for monitoring

LED Indicator (Receiver RX)
Connection indicator ：
Solid – connected ; Flash – disconnected ; Rapid Flash – connecting;

• Turn on the power on the receiver and the LED will flash. Then turn on the power button on the RX receiver, and WM820 will automatically pair the transmitter to the receiver and the LED will remain solid.

Battery LED Indicator :
No LED = battery level is above 20%
Red LED flash = battery level is below 20%
Solid Red LED = charging. Once fully charged, the red light will turn off

Technical Specification

Technical support:

support@maono.com
www.maono.com

Company：Qing UG（haftungsbeschränkt）
Address: Undinestr. 7,12203 Berlin Germany
Tell: 004917662179550
E-mail: pmdheinrich@gmail.com
Company: CET PRODUCT SERVICE LTD.
Address: Chase Business Centre, 39-41
Chase Side, London N14 5BP United Kingdom
Email: info.cetservice@gmail.com
TEL: +447419325266

V2.0_20210820

Documents / Resources

| maono WM820 Wireless Microphone System [pdf] User Guide
WM820, 2AJJB-WM820, 2AJJBWM820, WM820 Wireless Microphone System, Wireless Microphone System
---|---
| maono WM820 Wireless Microphone System [pdf] User Guide
WM820, Wireless Microphone System, WM820 Wireless Microphone System

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>