T7X Frigga (Multiple-use) Instruction Manual
- June 6, 2024
- FRIGGA
Table of Contents
Frigga T7X (Multiple-use)
Appearance Instruction
Note： The AC code（Activation code）is in the back of the device.
Display Instruction
Start:
Long press the “Start/Stop” button till “REC” has been showing on the LCD
interface, the device is ready to monitor.
At the same time, the record quantity also will be shown on the LCD interface.
Stop:
Long press the “Start/Stop” button till “REC” disappears from the LCD interface, the device has been stopped.
BT Print
Turn on the BT printer first.
Long press the “Print” button 3 sec., and the logger will connect printer
automatically and print data.
Check data
Short press the “Data” button, to show some information:
MAX temperature value
MIN temperature value
Mode Switch
-
Long press the “Mode” button, to enter flight mode:
In-flight mode, the logger only records data and doesn’t send data to the platform.
LCD will be shut down, display nothing. -
Long press the “Mode” button again, to quit flight mode:
Data report, LCD show, everything back to normal
Usage scenarios
Put the device in the container with goods together, it is not for portable
use.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operated in
conjunction with any other antenna or transmitter.
To maintain compliance with FCC’s RF exposure guidelines, This equipment
should be installed and operated with minimum distance of 20cm from your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>