KICKER KPBRC Power Bar Remote Control Instructions
- June 6, 2024
- KICKER
Table of Contents
KICKER KPBRC Power Bar Remote Control
Overview
- Double click pairing “ ” button to pair wireless remote with receiver.
- Press “+” & “-” for level up & down
- Press “ ”&“ ”for track forward & backward
- .Press “ ” to play and pause music
- Double tap “ ” to switch between Bluetooth and Aux modes
- LED low battery indicator (Green), operation indicator (Blue) & charging indicator (Red).
Battery Charging
Open the cover at back of the unit, you will see the micro USB charging port.
Plug in any micro USB cable to charge the battery, the red LED stays on. When
it is fully charged, the red LED stays off.
Steering Wheel/Bar Mount
Snap the unit into the plastic adaptor. Using the included rubber band for
steering wheel & bar mounting, hold the rubber against the steering wheel.
Wrap it around, then hook it up.
ISED Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>