Finemold Technologies PROBE T Smart Wireless Thermometer User Manual

PROBE T
Smart Wireless Thermometer

PROBE T Smart Wireless Thermometer

Thank you for choosing PROBE T ! Only a few steps away to use the PROBE T for cook.

Get Started

Charge PROBE T for 5-10 Minutes

Download the PROBE T App

IOS Android
Apple store / Google Play
Launch the PROBE T APP

Remove the PROBE T probe from the charger to turn it on

Follow the App instructions to pail the PROBE T probe for the first time Charger LED Status Indicator

• Solid Green: Full Charge
• Solid Red: In the charging

Notice No Power Switch The power is constantly consumed. Please charge the probe before use.

Specification

**** Warnings

• PROBE T is designed for use in meat(food).
• The charger block is non-waterproof, do not immerse it in water or other liquids.
• To avoid damage to PROBE T, insertion of the probe in the meat past the Safety Notch in necessary.
• Do not use PROBE T probes in a microware or pressure cooker.
• PROBE T probes are not dishwasher safe. Please hand wash with soap and water before and after each use.
• PROBE T is water resistant, not fully waterproof, do not submerge in water for long periods of time. –
• Please take caution with the pointed tip of the probe.
• Probe will be very hot during or just after a cook. Do not touch with bare hands.
• Do not submerge the PROBE T probe in cold water after cooking. Wait until it has cooled down prior to washing.
• PROBE T is not a toy, please keep it away from children.
• The internal sensor max is 212 °F (100 °C). Temp above the maxi-mum may potentially damage PROBE T
• When cooking, ensure any part of the probe is not touching any HOT cooking surface.
• When not in use, store PROBE T in a dry and cool place.

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interf-erence, and
2. this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party respon-sible for compliance could void the users authority to operate the equipm-ent.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These lim- its are designed to provide reasonable protection against harmful interfere- nce in a residential installation. This equipment generates uses and can rad- iate radio frequency energy and, if not installed and used in accordance wi-th the instructions, may cause harmful interference to radio communicatio-ns. However, there is no guarantee that interference will not occur in a par- ticular installation. If this equipment does cause harmful interference to ra- dio or television reception, which can be determined by turning the equip-ment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
  *RF Exposure information: The device has been evaluated to meet general RF exposure requirement.
  The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>