Epic Video Technologies TX1 Android TV Box User Manual
- June 6, 2024
- Epic Video Technologies
Table of Contents
TX1 Android TV Box
USER MANUAL
1. Network
1.1. Wi-Fi
Check “Wi-Fi”, System will start scanning available wireless access points
around you automatically. Choose an access point and enter the password.
After authenticating IP address will be given to the box and “connected” is
shown, wireless connection is available now.
Notice: Wi-Fi connection and Ethernet connection are mutually excluded
1.2. Ethernet
Click “Ethernet”, box will start DHCP process automatically. Box will
automatically stop Wi-Fi connection and Up Ethernet connection at the moment
when Ethernet jack is plugged in. When the IP address appears, the network
connection is available.
2. Upgrade Steps
-
Copy OTA zip file into TF card or USB storage device.
Insert HD cable and TF card(USB storage device) with the box. -
Connect the other side of the HD cable to the TV HD port.
-
Insert a stick into the hole below the device . There is a reset button inside the hole. And keep pressing the button.
-
Insert power adapter. (Still pressing the button)
-
Pressing the reset button and hold until you see the android reboot. And use the remote to choose “apply update from EXT” choose “Update from TF card”(choose “Udisk” if USB storage device is applied) choose “xxx.zip (theupgrade package file)” and press OK.
-
You will see “—install/ SD card…” It means the box is upgrading.
After upgrade, you can see “Install from SD card complete” at the bottom.
Use remote to choose “reboot system now” and press OK
Or plug the power adapter again to reboot the box. -
Upgrade finished. You can see the “Welcome” interface.
Tips: You can check the build number in settings to confirm you have updated the box successfully.
3. Trouble Shooting
FCC Cautions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set for this for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.