Dongguan Xinvouc Electronic BT-01 Built In Wireless Headphone for Your Music And Calls User Manual
- June 6, 2024
- Dongguan Xinvouc Electronic
Table of Contents
Dongguan Xinvouc Electronic BT-01 Built In Wireless Headphone for Your
Music And Calls
Precautions
- DO NOT Expose Product liquids or Moisture
- DO NOT Attempt to temper with Product By Dropping, Disassembling, Opening or Scratching, etc
- DO NOT Store Product Near Acidic or Alkaline Material
- Take Out the Heed phones Before Washing
- Keep the: Product Away From Fire
- Note: When not used for 3-6 months, you need to charging once
Features
- Could activate SIRI on IOS device for commands
- Built-in Microphone for Hands Free Talking
- Headphones are Removeable for Headwear Washing
- Product Is Rechargeable Through Universal Micro -USB Cable
Specifications
- Wireless version; V5.0
- Frequency: 2.402 GHz-2.480 GHz
- Transmission Range: !OM/ 33Ft
- Rated Power: RMS 10mW x 2
- Speaker Unit: 32QJ3Dmm
- Battery: 3.7V 18DmAh Rect11rgeeble LI-polymer Battery
- Standby TI me: Over 120 Hours
- Play Time: Over 12 Hours
- Charge Time: 2H
- With Over-Current, Overcharge and Overheat Circuit Protection Design on PCB
Instructions
PAIRING TO YOUR DEVICE
Charging Instructions
- Fully charge battery before first use.
- Use the supplied USB cable, simply plug into the charging port of the headwear
- Now plug the other end of the USB cable into your PC or laptop.
- During charging, the LED Status Light will turns to be red on the control panel.
- When charging is a:xnpleh!d, the red light will change to blue.
- It will 1 about one hour to gat the battery full charged.
Buttons Interface
-
Volume Down (long press} Previous Song (short press}
-
Play/Pause/Answer/Hang Off/Redial
Power On/Power Off (long press} Play/Pause (short press}
Answer/Hang Off (short press) Redial (double click) -
Volume Up {long press) / Next Song (short press) O LED Stat us Light
-
Long press Play/Pause button for 2 seconds to reject a incoming call.
FCC
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>