T Mobile Usa TMO-SKW-01 Wearable Device Instructions

Electronic Devices

• Do not use this device in places where it is expressly forbidden to use electronic devices. The radio waves generated by this device may interfere with other devices and cause accidents or damages.
• Please observe the rules for using such devices during a flight. It may interfere with the flight system. Please comply with the flight regulations.

Medical Safety

• This device is not a medical device. Any data/information provided in relation to this product should not be used as the basis for the diagnosis, treatment, and prevention of diseases.
• Please observe the rules and turn off this device in medical areas where it is expressly forbidden to use wireless electronic devices.
• The radio wave generated by this device may interfere with the normal operation of medical devices. If this device needs to be used along with a medical device, please consult the manufacturer of the medical device for the conditions.

Allergic Reaction
If you get an allergic reaction, itchiness, red marks, or rashes on the skin after wearing the watch, please do not panic. It depends on the physical conditions of different people. In normal cases, this is caused by hyperfunction of the immune system, rather than an issue with the watch itself.

Skin itchiness and rashes caused by wearing the watch can be classified into the following three types:

1. Silicone allergy: If you are allergic to the silicone strap, you need to replace it with another strap of a different material.
2. Allergy to dirt or sweat on the watch: If the watch has not been cleaned for a long time, gently wipe it with a wet towel.
3. Allergy due to the strap being too tight: Loosen the strap to increase ventilation and air permeability. If the skin irritation persists for a long time, we recommend seeking medical care as soon as possible.

Safety Guidelines About Charging
Use only the charger supplied with your device. Use of another type of charger will result in malfunction and/or danger. Do not use the charger in a high moisture environment. Never touch the charger when your hands or feet are wet.

• Allow adequate ventilation around the charger when using it to operate the device or charge the battery. Do not cover the charger with paper or other objects that will reduce cooling. Do not use the charger while it is inside a carrying case.
• Connect the charger to a proper power source. The voltage requirements are found on the product case and/or packaging.
• Do not use the charger if the cord becomes damaged.
• Do not attempt to service the unit. There are no serviceable parts inside. Replace the unit if it is damaged or exposed to excess moisture.

About The Battery
This unit contains a non-replaceable internal Lithium-Ion battery.
The battery can burst or explode, releasing hazardous chemicals. To reduce the risk of fire or burns, do not disassemble, crush, puncture, or dispose of in fire or water.

IEEE 1725 Battery Safety Statement

• Do not disassemble or open crush, bend or deform, puncture or shred.
• Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids, expose to fire, explosion, or another hazard.
• Only use the battery with a charging system that has been qualified with the system per CTIA Certification Requirements for Battery System Compliance to IEEE 1725. Use of an unqualified battery or charger may present a risk of fire, explosion, leakage, or another hazard.
• Replace the battery only with another battery that has been qualified with the system per this standard, IEEE-Std-1725. Use of an unqualified battery may present a risk of fire, explosion, leakage, or another hazard. Only authorized service providers shall replace batteries.
• Promptly dispose of used batteries in accordance with local regulations.
• Avoid dropping the Wearable Product. If the Wearable Product is dropped, especially on a hard surface, and the user suspects damage, take it to a service center for inspection. Improper battery use may result in a fire,
• explosion, or another hazard. For Wearable that utilizes a USB port as a charging source, the Wearable’s user manual shall include a statement that the Wearable shall only be connected to CTIA certified adapters, products that bear the USB-IF logo, or products that have completed the USB-IF compliance program.
• The Wearable product, including the power supply, should not be left in the rain or subjected to exposure to water. If cleaning is necessary do not immerse in water; wipe clean with a damp cloth.
• The Wearable product, including the power supply, should not be dropped, crushed (stepped on), or otherwise abused.
• The user should be careful with the interconnect cable (wiring) between the power supply (adapter) and the Wearable product, in particular as a potential trip hazard.

Federal Communications Commission (FCC) Statement
§15.19 (a)(3)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

§15.21
Any changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
§15.105 (b)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC RF Radiation Exposure Statement
This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government.
The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate or SAR. The SAR limit set by the FCC is 1.6 W/kg for 1g SAR and 4.0 W/kg for 10g SAR. Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. This is because
the device is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station
antenna, the lower the power output.
The highest next-to-mouth exposure SAR value for the model device as reported to the FCC when tested is 1.22 W/kg(1g) and the highest wrist-worn SAR value is 1.85 W/kg(10g) as described in this user guide. While there may be differences between the SAR levels of various devices and at various positions, they all meet the government requirement. During testing, the device is set to its highest transmission levels and placed in positions that simulate use against the head, with 10mm separation, and on the wrist, with no separation. When placing the device near your face, keep at least 10mm of separation to ensure exposure levels remain at or below the as-tested levels.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated are in compliance with the FCC RF exposure guidelines. SAR information on this model was found under the Display Grant section of www.fcc.gov/oet/ea/fccid after a search on FCC ID 2ASXC-TMO-SKW-01. the device is on file with the FCC and can be

Safety & Regulatory Information
Before using this device, please read and observe the following precautions to ensure the best performance of the device and avoid dangerous and illegal situations.
Important Safety Information for Children

1. Not recommended for children under 3 years old.
2. The adapter should not be handled by children.
3. Precautions should be observed during handling to prevent electric shock and high temperature.
4. This product including the adapter should not be left in the rain, exposed to water dropped and crushed, or otherwise abused.
5. An adult should inspect the product including the adapter as applicable periodically for damage, and replace it if necessary.
6. Children should be careful with the interconnect cable between adapter and device, in particular as a potential trip hazard.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>