poldina LD0286B3 Pendant Light Instructions
- June 6, 2024
- poldina
Table of Contents
Lampada a sospensione ricaricabile
• Rechargeable suspension lamp
lampada a sospensione ricaricabile / rechargeable suspension lamp
LED DIMMER
2,2W • 192-200lm
2700-3000K • IP65
CRI>80 • 5Vdc max 1A
Ø 198 x 198 cm / Ø 7,8 x 7,8 in
L D0286B3 bianco / white
LD0286N3 grigio scuro / dark grey
LD0286R3 corten
Inclusi / Included
Cavo di ricarica con entrada USB Tipo C / Charging cable with USB Type C input
Noninclusi / Not included
LD0340RA
Caricature multipresa USB (8xUSB)/ Multi-socket USB charger (8xUSB)
BAT04703706701900
Pacco batteria sostitutiva / Replacement battery pack
KIT00009006800201
Scheda LED sostitutiva/ Replacement LED board
Tips for use:
A) Installation and maintenance must be done when full power is switched off. B) Modifications or handling of the product and the non-respect of the information below may be dangerous. C) The assembled lamp (head + frame), reaches an IP54 degree of protection which makes it suitable for outdoor use. The light diffuser only (head) has a degree of protection IP20 and used individually is not suitable for outdoor use. D) Cleaning of all metal and plastic surfaces using a soft dry cloth. E) The company Zafferano assumes no responsibility for damages caused by a product installed not in accordance with instructions.
Technical data of the lamp:
Lithium battery pack included (see section accessories included); for
instructions about how to replace the battery pack, please consult the
website: www.zafferanoitalia.com. Use only
original batteries for replacement.
– Ricarica / Charge: 6 h
– Durata batteria: / Battery life: 9 h
– Classe / Class: III
– Grado di protezione / Protection rating: IP54
– CRI>80
Battery charger technical data:
It is advisable to use the original charger and charging base. Alternatively, you can use a certified 1A max. charger.
important:
please refer to local laws for the proper disposal and recycling of the battery
ASSEMBLY INSTRUCTIONS
Important! Don’t tighten too hard
INSTRUCTIONS FOR USE
SWITCHING ON
quickly press the touch sensor to switch on the lamp
SWITCHING OFF
quickly press the touch sensor to switch off the lamp
DIMMER
when the lamp is switched on, lightly press the touch sensor to obtain the desired brightness
COLOR TEMPERATURE CONFIGURATION
When the lamp is switched off, press lightly for 4 seconds until a steady blue LED lights up
A quick tap on the touch sensor to change the color temperature of the lamp
Light pressure for 4 seconds to set the new color temperature and switch off the lamp
CHARGE
Charge the battery before initial use. To correctly charge the lamp, we recommend that you:
- Connect the USB cable to the adaptor; 2) Connect the USB cable to the lamp;
- Put the plug into the electrical socket; 4) When fully charged, disconnect the plug from the electrical
INDICATOR LEDS
charging in progress
GREEN LED
the battery is charged, it is advisable to disconnect it from the power charger
INCLUDE AND NOT INCLUDED ACCESSORIES
INCLUDED
Charging cable with USB Type C input
| INPUT: 5Vdc max 1A
OUTPUT: 5Vdc max 1A|
---|---|---
| INPUT: AC100-240V 50/60Hz
OUTPUT: 5Vdc max 1A| 
NOT INCLUDED
LD0340RA
Multi-socket USB charger (8xUSB)| | INPUT: AC100-240V 50/60Hz
OUTPUT: 5Vdc max 8A| 
---|---|---|---
REPLACEMENT
Replacement LED board
KIT00009006800201
Scan the QR code to see how to replace the LED board of your lamp.
http://qr.w69b.com/g/lbNfgxIac
**BAT04703706701900***
Replacement battery pack
*BAT04703706701900 x 1 pz**
Scan the QR code to see how to replace the exhausted batteries of your lamp.
http://qr.w69b.com/g/teAkpChEI
RECHARGEABLE BATTERY MAINTENANCE
All rechargeable batteries are subject to wear when used. The life of batteries, which can generally be recharged 450 times, may be reduced by certain factors:
- incorrect recharging mode (the lamp must be recharged when it is flat: about 10% of its remaining autonomy);
- when left unused for a long time;
- when left for a long time on a live recharging base even if the lamp is recharged;
- when non-original accessories are used for recharging;
- when the product is exposed to very high or very low temperatures. When the lamps no longer recharge or their autonomy after recharging is very short, the batteries must be replaced. Spare parts for Zafferano rechargeable lamps can be found in the catalogue and identified by a special code. The warranty for batteries is only valid for manufacturing defects, which may occur after initial use.
LEGEND
|
User-replaceable source
---|---
| User replaceable light source
| User-replaceable LED source
| LED source replaceable by qualified personnel
| Non-replaceable LED source
| User-replaceable driver
| Driver replaceable by qualified personnel
| Non-replaceable driver
| User-replaceable battery
| Battery replaceable by qualified personnel
| Non-replaceable battery
---|---
https://www.zafferanoitalia.com/lampesaporter/it/
Zafferano SRL
www.zafferanoitalia.com
Tableware Department
Lighting Department
+39 0422 470344
info@zafferanoitalia.com
+39 0422 470 507
vendite@zafferanoitalia.com
For more information and updates visit our website • www.zafferanoitalia.com