Twiins HF3 Handsfree Bluetooth for Helmets Instruction Manual
- June 6, 2024
- Twiins
Table of Contents
INSTRUCTION MANUAL
Intercom pairing
Helpful Hint #1: Activation will be easier if you wait to install the
HF3.0 into your helmet after all other steps have been completed.
Helpful Hint #2: Intercom functionality can only be activated or
deactivated by the HF3 INTERCOM. When pairing with any other HF device, the
HF3 becomes the controlling unit, while all other HF devices become the
partnered unit. Partnered units cannot activate or deactivate intercom
functionality.
DUAL-LINK: PAIRING AS AN INTERCOM WHILE MAINTAINING HANDS-FREE FUNCTION
Step 1: Pair each device with its related phone as described in “How to Pair
Your Twiins® HF Device With Your Phone”. The same process applies here. Each
HF device will need to be paired with a corresponding phone. Note: You’ll want
to make sure the HF3 is paired with the rider’s phone. The HF2 or other HF
device will be paired with the passenger’s phone.
Step 2: Switch off Bluetooth® on both phones. S
Step 3: Switch off both Twiins devices.
Step 4: Press and hold the control button (lb) on both Twiins devices until
the LED indicators of both devices begin flashing in red and blue.
Step 5: Press the control button on the Twiins HF3 device for two seconds.
After five seconds, both devices will pair and the intercom function will be
activated.
Step 6: Switch on the Bluetooth® on Phone 1 linked with Twiins HF3 device. If it does not pair automatically, select HF3 from the Phone 1 Bluetooth screen. Press the control button of the second Twiins device for five seconds and it will switch off.
Step 7: Press the control button again for two seconds and the second device will switch on again. After several seconds, the Twiins® HF3 and second device will pair automatically. and will beep briefly. Switch on the Bluetooth® of Phone 2. Select Twiins second device on the screen. Phone 2 and the second device will be paired again, while both Twiins® will be paired in INTERCOM mode, and the Phone will be paired with HF3.
SINGLE LINK: PAIRING HF DEVICES AS INTERCOM ONLY (WITHOUT HANDS-FREE
FEATURES)
Step 1: Make sure both Twiins devices are switched off.
Step 2: Press and hold the control (lb) buttons of both Twiins devices until
the respective LED indicators flash in red and blue Step 3: Press the control
button of this Twiins HF3 device for two seconds. After a few seconds, both
devices will briefly beep, and they will be paired. The intercom function will
be activated.
ACTIVATING / DEACTIVATING INTERCOM FUNCTIONALITY
Once both Twiins devices have been paired and switched on, press the HF3 control button (lb) to activate or deactivate Intercom functionality. When activating/deactivating both devices will beep briefly.
ADJUSTING VOLUME FOR INTERCOM FUNCTION
Step 1: You can adjust the volume by briefly pressing the control button of the HF3 Step 2: It will then cycle through three levels: Low < Medium < High.
PLEASE NOTE
To use HF1 HF2 or HF3 devices in GROUP TALK mode, please disconnect the
INTERCOM TO PASSENGER function.
To use the INTERCOM TO PASSENGER function, please make sure you have logged
out from the GROUP TALK APP and closed the APP.
To use this HF3 INTERCOM with any other device than Twiins: please make sure
other devices have the INTERCOM function, and it uses open Bluetooth
protocols, without passwords. Please, when connecting both devices, press
HF3_INTERCOM to pair the other device.
TROUBLESHOOTING: Please follow our Video Tutorials or check our F.A.Q at www.twiinsUSA.com