MARLEY EMDE031 Redemption ANC 2 Earbuds User Guide
- June 6, 2024
- MARLEY
Table of Contents
Redemption ANC 2 Earbuds
User Guide
DOWNLOAD THE APP
https://www.thehouseofmarley.com/app
PLAY/PAUSE
MONO MODE
PAIR NEW DEVICE
NO CASE ON/OFF
i. Initial Set Up & Pairing:
- Open Case.
- Remove earbuds and remove the paper film from the bottom.
- Place earbuds back into the charging case and leave closed for 15 minutes before the first pair.
- Remove earbuds from the charging case and they will automatically go into pairing mode indicated by alternating red/white flashing on one of the earbuds.
- Select “Redemption ANC 2” from your device’s Bluetooth® menu.
- Once paired, simply removing earbuds from the case will automatically pair to your device
- Download the House of Marley app on your device’s app store for added functionality.
2. Battery Life: Tap the case to check the battery level. LEDs on the
case will indicate status.
3. Force pair to New Device:
- Open case lid and place earbuds in ears, tap either earbud 5 times, the pairing mode will sound and alternating red/white LED on earbud will begin.
4. Reset Earbuds to Factory Settings:
- Remove earbuds from the case. Press and hold on each earbud for io seconds to force the earbud to power off (3 red flashes will indicate power off).
- Wait io seconds
- Press and hold on both earbuds until white/ red flashing is showing, continue to hold until earbuds flash red 3 times, and power off.
- Return earbuds to case and close lid.
- Upon opening the charging case, earbuds will be reset to factory settings.
Full instruction and warranty details can be found at https://www.thehouseofmarley.com/customer-support/instruction-books
COMPLIANCE INFO
REDEMPTION ANC 2
READ ALL INSTRUCTIONS BEFORE USE AND SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
WARNING: For Australia and New Zealand for charging this equipment, only
use Australian approved detachable power supply unit with the output ratings
of 5V DC, 500 mA.
FCC RF EXPOSURE STATEMENT: This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter. This device
complies with FCC radiation exposure limits set forth for an uncontrolled
environment. CAUTION! Any changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
ISEDC STATEMENT: This device complies with Innovation, Science, and
Economic Development Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device. This Class B
digital apparatus complies with Canadian ICES-003.
ISEDC RF EXPOSURE STATEMENT:
The device is compliant with RF exposure guidelines, users can obtain Canadian
information on RF exposure and compliance. End-user must follow the specific
operating instructions for satisfying RF exposure compliance. The portable
device is designed to meet the requirements for exposure to radio waves
established by the Federal Communications Commission (USA). These requirements
set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR
value is reported under this standard during product certification for use
when properly worn on the body.
BATTERY REPLACEMENT STATEMENT IN EUROPE
Your Redemption ANC 2 includes a rechargeable battery designed to last the
lifetime of the product. In the unlikely event that you should require a
replacement battery, please contact Consumer Relations who will supply details
of the warranty and out-of-warranty replacement battery service.
CAUTION Risk of explosion if the battery is replaced by an incorrect type
— replacement of a battery with an incorrect type that can defeat a safeguard
(for example, in the case of some lithium battery types);
— disposal of a battery into fire or a hot oven, or mechanically crushing or
cutting of a battery, that can result in an explosion; — leaving a battery in
an extremely high temperature surrounding environment that can result in an
explosion or the leakage of flammable liquid or gas;
— a battery subjected to the extremely low air pressure that may result in an
explosion or the leakage of flammable liquid or gas. BATTERY DIRECTIVE
This symbol indicates that batteries must not be disposed of in domestic waste
as they contain substances that can be damaging to the environment and health.
Please dispose of batteries in designated collection points.
WEEE EXPLANATION
This marking indicates that this product should not be disposed of with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources.
Hereby, FICA Brands Ltd, declares that this radio equipment is in compliance
with the essential requirements and other relevant provisions of Directive
2014/53/EU. A copy of the Declaration of Conformity can be obtained from
www.thehouseofmarley.co.uk/declaration-of-
conformity
To prevent possible hearing damage, do not listen at high
volume levels for long periods. Full instruction and warranty details can be
found at http://www.thehouseofmarley.com/instructionbooks.
Marley and the Marley logo are registered trademarks of Fifty-Six Hope Road
Music Limited and the use of such marks by House of Marley is under license.
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetootlf SIG, Inc. and any use of such marks by The House of Marley is under
license.
Operating frequency band: 2402 – 2480MHz
CE BT Max Power Transmitted Power: Left Ear:11dBm, Right Ear:11dBm
Distributed by House of Marley, LLC, 3000 N. Pontiac Trail, Commerce Township,
MI 48390.
Distributed in Australia by HoMedics Australia Pty Ltd, 14 Kingsley Close,
Rowville, Victoria 3178.
QS-EMDE031
Right Earbud EM-DE031R
FCC ID: PVB-EMDE031R
IC:10613A-EMDE031R
Left Earbud EM-DE031L
FCC ID: PVB-EMDE031L
IC: 10613A-EMDE031L
The charging case should be installed and operated with a minimum distance of
20cm between the radiator and your body when it is charged.
BOB MARLEY MARLEY’ BOBMARLEY.COM
©Fifty-Six Hope Road Music Ltd., 2011-2021. Right of Publicity and Persona
Rights. Fifty-Six Hope Road Music Ltd. EM-DE031
Marley, the Marley logo, Bob Marley and the Bob Marley Logo have registered
trademarks of Fifty-Six Hope Road Music Limited and any use of such marks by
The House of Marley is under License. The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth® SIG, Inc. and any use of such marks
by The House of Marley is under license.