ILIFE W100 Cordless Wet and Dry Vacuum Cleaner User Manual
- June 6, 2024
- iLIFE
Table of Contents
ILIFE W100 Cordless Wet and Dry Vacuum Cleaner
Important Safety Instruction
Safety Warnings
- Product disassembly is strictly prohibited;
- Before cleaning or maintaining the Product, please unplug the power adapter and turn off the power source;
- To prevent potential electric shock risk, plz don’t touch plug, power adapter or machine monitor when your hand is attached with water ;
- Please only use the power adapter that comes with the product ,if you use other power adapters, it may damage the machine;
- If the power adapter is damaged, please stop using it immediately and contact the official after sale team for replacement;
- The Product is not suitable for people with physical, sensory or mental disabilities or lack of common sense (including children), unless supervised or directed by others to ensure the safe use;
- During operation, in case of electric leakage of the machine or excessive temperature and abnormal noise of the motor, such as the body overheating, abnormal noise, odor and other problems, please stop the machine immediately, and contact the Official After-sales Team for help;
- Do not moisten the machine body; otherwise it may cause fire and electric shock due to short circuit;
- Do not block the air inlet and outlet to avoid overheating of the machine;
- Do not soak the floor brush with water to avoid overburning of the machine;
- Do not shake or collide the machine violently to avoid dirty water flowing into the motor;
- When handling the machine, please keep it upright to avoid sewage flowing into the motor;
- If the clean water tank and dirty water tank are not installed in place, do not use the machine;
- Do not use the machine when the current temperature is below -l0°C or above 45°C;
- The Product is only suitable for use in the household environment, not in the industrial environment or outdoor environment;
- The Product is suitable for the hard floor in the household environment, such as marble floor, wood floor, tile floor, solid wood floor and composite floor;
- To avoid fire,do not use the Product to clean cigarette butts, matches and other unknown heat sources;
Important Safety Instruction
- Do not use the Product to clean flammable, explosive or highly volatile liquids, such as gasoline, kerosene, paint and perfume, which may cause short circuit or explosion of the Product;
- Do not use the Product to clean the toner or color blender used in the laser printer and copier to avoid fire or explosio;
- Do not use the Product to clean sharp objects, such as glass fragments, thumbtacks, nails, clips, stones and other articles, so as to avoid damage to the Product;
- Do not use the Product to clean pigment, paint, shoe polish and other strongly dyeing stains;
- Do not use the Product to clean foam liquid to avoid damage to the motor;
- Keep the cleaning solution out of the reach of children;
- Please follow the instructions to use the cleaning solution;
- Do not add alcohol to the clean water containers.
Product Introduction
List of accessories
Product Description
Product Operation
lndiactor Screen lnstroduction
Assemble and Detach the Device
Disassembly and assembly of handle
Assembly:
Insert the connecting pipe of handle into the machine body assembly port, and
the “click” sound means the completion of assembly.
Disassembly:
Use a screwdriver or other tool of the right size to insert the hole in the
upper back of the machine body and press it, while lifting the handle upward.
Assembly of clean water tank
Open the cover of clean water tank as shown in Fig 2.1 and fill it with clean water as shown in Fig. 2.2; install the clean water tank as shown in Fig. 2.3, and the “click” sound means the completion of assembly.
Assembly of dirty water tank
As shown in Fig. 3.1, put the bottom of dirty water tank at the opening of the machine body and gently push it inward, and the “click” sound means the completion of assembly.
Assembly of roller brush
As shown in the figure below, align the groove on the right side of the rolling brush with the transmission shaft, and then press down the left side of the rolling brush until it is assembled in place.
Assembly of transparent window of roller brush
As shown in the figure below, lock the buckle under the transparent window cover of rolling brush, then lock the latch to the ground brush, and the “click” sound meansthe completion of assembly.
Charging Dock
Plug the adapter charging port into the corresponding position of the docking
station, and connect the adapter head to the household socket.
How to use
Charging
As shown in the figure below, align the machine with the charging base; the charging will begin when the battery contact properly connects with the charging base contact.
Self-cleaning
When the machine is charging on the docking station, press the self-
cleaning button to enter the self-cleaning mode. (Please make sure there is
water in the clean water tank during operation).
Operation
Tilt the machine body to an appropriate angle and press the On/Off button to start the machine.
Note:
- During operation, in case of a lot of foam in the dirty water tank, please clean up the dirt in the tank in time to prevent water from entering the fan.
- Do not push and pull quickly during operation to prevent water from entering the fan.
- During operation, please observe the dirt in the dirty water tank to avoid blocking of the float with suspended matter and impact on the full water detection.
- Please turn off the power of the machine before charging.
Maintenance
Fill and clean Dirty Water Tank
Clean the dirty water tank and upper cover immediately after use to avoid
stinky smell.
Hold the notch of clean water tank by hand, press the latch with your thumb
and pull the sewage tank out gently.
Detach and clean Roller Brush
After cleaning, enter self-cleaning mode of the machine. If the roller
brush is too dirty, take out the roller brush according to the figure below
and clean it by yourself.
Detach and clean HEPA Filter
Remove the HEPA Filter of the dirty water tank according to the figure
below, and place it at the vent to dry after cleaning.
Product Technical Parameter
| Item | Cordless Wet &Dry Vacuum Cleaner |
|---|---|
| Model | WlOO |
| Net weight | ~4 .2kg |
| Capacity of clean water tank | 0.6L |
| Capacity of dirty water tank | 0.5L |
| Size | 1170 X 280 X 250mm |
| Rated voltage | DC 21.6V |
| Rated power | 150W |
| Battery capacity | 3000mAh |
| Noise | ~75dB |
| Adapter input | 100-240V~50/60Hz 0.8A |
| Adapter output | DC 27V 800mA |
| Charging duration | ~4h |
Battery usage
| ~35min for standard gear
~30min for strong gear
Common Failure Analysis and Treatment
Fault Code List
| Fault Code | Causes | Solutions |
|---|---|---|
| El | Battery wire is broken | Replace the battery pack |
| E2 | Voltage of the rechargeable battery is too low | Replace the battery pack |
E3
| Differential voltage of the rechargeable battery is too large| ****
Replace the battery pack
E4| Temperature control of the battery pack is abnormal| Replace the battery pack
E5
| ****
High temperature during discharging
| Temperature of the battery pack is high, use the battery pack after its temperature cools down
E6
| High temperature during charging| Temperature of the battery pack is high, charge the battery pack after its temperature cools down
E7
| Low temperature during charging| Please charge the machine at ambient temperature >5°C
Fl
| ****
Overcurrent during charging
| Please confirm whether the charger is original from the machine packing
F2
| ****
Short-circuit protection
| Please contact Customer Service Department
F3
| ****
Overcurrent during working
| Please contact Customer Service Department
F4
| ****
Overcurrent of ground brush during dischargin
| Check whether there is any foreign matter to be cleaned on the rolling brush. If the fault still exists, please contact Customer Service Department
F6
| No dirty water tank is installed| Install the dirty water tank before use
Disposal
The battery used with this device must not be disposed of in household waste.
The device and the battery must be disposed of properly. The housing of the
battery must never be opened, and must be disposed of as a whole.
This product is subject to the provisions of European Directive 2019/19/EC.
The symbol showing a wheelie bin crossed through indicates that the product
requires separate refuse collection in the European Union, This applies to the
product and all accessories marked with this symbol. Products identified with
this symbol may not be discarded with normalhousehold waste, but must be taken
to a collection point for recycling electric and electronic appliances.
Packaging
When disposing of the packaging, make sure you comply with the environmental regulations applicable in your country.
Distributor: Zhiyi (Zhongshan) Technology Co., Ltd.
No. 39, Donghui Road, Cuiheng New District,528400 Zhongshan, Guangdong,
PEOPLE’S REPUBLIC OF CHINA
EASINE Customer Service
Call 1-800-631-9676 (Toll free for
North America)
Mon-Fri: 8:00 am – 7:00 pmCST
@support-usa@easine.com
Documents / Resources
|
ILIFE W100 Cordless Wet and Dry Vacuum
Cleaner
[pdf] User Manual
W100, Cordless Wet and Dry Vacuum Cleaner
---|---
|
ILIFE W100 Cordless Wet and Dry Vacuum
Cleaner
[pdf] User Manual
W100, Cordless Wet and Dry Vacuum Cleaner, W100 Cordless Wet and Dry Vacuum
Cleaner
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>