SOLTECH CEGONIA PRO 30W Elegant and Convenient Solar Street Lighting Installation Guide
- June 6, 2024
- SOLTECH
Table of Contents
SOLTECH CEGONIA PRO 30W Elegant and Convenient Solar Street Lighting
Installation Guide
Introduction
Thank you for purchasing CEGONIA PRO solar-powered area light.
Introduction
CEGONIA PRO combine stylish design with hight efficiency. You can adjust both the tilt angle and the azimuth to make sure the panel is in the optimal position to capture the sun’s energy. It is a perfect fit for courtyards, parks, schools, communities and paths.
Important Considerations
In order to avoid deep discharge of the battery during storage, please fully recharge your battery every 4 months. Please make sure that the light is installed in an area with sufficient sunlight irradiance. A strict minimum of 3.5 hours/day of sunshine on average is recommended. Select the right operating mode according to local codes & regulations, and the local sunshine conditions. Keep it away from shadows. Self-cleaning occurs when the light fixture has a minimum angle of 15 degrees.
Please save these installation instructions. Read all of the instructions carefully before attempting to carry out any installation or wiring. Do not open or attempt to repair the product on your own, as it many cause serious damage and would void the product warranty. Contact your local distributor for any questions concerning the installation.
Range of the light module on the lighting fixture is 20–26 feet (6–8 meters). The ideal installation spacing is >16 feet (5 meters). When installing two or more lighting fixtures on one pole, select desired operating mode before installation. Interference can cause delay or malfunction when using the remote control to change operating modes after installation.
Range of the light module on the lighting fixture is 20–26 feet (6–8 meters). The ideal installation spacing is >16 feet(5 meters). When installing two or more lighting fixtures on one pole, select desired operating mode before installation. Interference can cause delay or malfunction when using the remote control to change operating modes after installation.
Precautions When Working With Solar Panels
When the solar panel is exposed to light, a voltage appears at the output terminals of the solar panel turning it into a source of electricity. To avoid a shock hazard, make sure the solar panel is covered with an opaque (dark) covering such as paper or cloth, during the installation. Do not make contact with the terminals when the panel is exposed to sunlight or any other light source.
CEGONIA PRO 30W
SOLAR PANEL: 9.9 Lbs
SOLAR LAMP: 13.6 Lbs
BATTERY ASSEMBLY: 25.9 Lbs
CEGONIA PRO 30W Type III
Battery Notes
- Super Capacitor battery-powered CEGONIA PRO lights are visibly brighter than other outdoor solar lights, and their performance overall is more reliable.
- To charge the battery fully may take up to 12 hours.
- The rechargeable battery can work continuously for 10 hours at full power.
- The output will be reduced to 40% when the battery is below 40% of its capacity.
- The battery will stop charging when the ambient temperature is below -40°F or above 140°F.
Battery Status is indicated by the red/green indicator on the light fixture as follows:
- Slow red light flashing (Every 2.5s) = Working
- Slow red flashing (Every 5s)= Open circurt
- Red light continuously on = Non-working
- Quick red flashing (Every 0.5s)= Charge fault
- Quick red flashing (Every 0.1s)= Over current or Short circuit
Storage
To avoid over discharge of the battery during storage, please recharge the lighting fixture every 3 months. Use the dedicated charger to charge, and then reset the switch when done.
(IAP) Intelligent Adaptive Program Battery Control Technology
In order to extend the off-grid autonomy of the CEGONIA PRO 30W under shade trees, heavy rain, and thick clouds, our controllers now integrate an adaptive smart control feature to actively track battery capacity and adjust light output accordingly. Before integrating this feature, selecting a light output percentage on the remote would yield an accurate percentage of max LED brightness. Activating the IAP, the controller actively monitors the battery and regulates the electrical current to the LEDs. The controller makes the light output of a selected percentage on the remote relative to battery capacity rather than max LED output. This smart-control feature can increase the fixture’s off-grid performance by up to 40%.
ATTENTION
Battery cannot be replaced on your own. Please conntact SOLTECH for any battery’s questions.
After connecting the wires between solar panel and the light, CEGONIA PRO 30W will automatically turn on, and the indicator will begin flashing every 2.5 seconds. The light fixture will then turn on for 1 minute and then shut off again. This means the fixture is switching from open circuit mode to standard working mode.
If you wish to shut off the light, you must first cover the solar panel. Then press the off button on the remote. You can also just press the off button to turn off the light at night. When the solar panel detects light, the fixture will activate and resume normal operation again.
Installation and Wiring Compliance
- Installation and wiring must comply with the State and National Electrical Codes.
- The CEGONIA PRO 30W model is intended for outdoor use only and should not be installed in an unventilated area. It must be in stalled in an environment within the operating temperatures defined for the product.
- The average sunshine in the installation area should be above 3.5 hours/day in order to ensure full function of the light fixture. Avoid areas with shades.
- Before installation, if applicable, ensure the light pole and its foundation are solid enough to support the light fixture(s).
- Before installation, ensure that the battery is fully charged. Install during sunny days if possible.
- Before installation, press the ON/OFF key in the remote control and check whether it shows a red light on the indicator. Cover the panel and check if the light module turns on normally within 1 minute.
After Installation
The light fixture will automatically turn on at night and turn off during daylight.
Important Considerations
Orient the solar panel facing the equator
(e.g. facing south if in northern hemisphere).
Have a tilt angle of at least 15° to avoid dust accumulation
(0°=horizontal plane).
Mounting Accessories
A. TRUNNION— Wall Mount
B. TRUNNION— Round
C. TRUNNION— Square
Installation
CEGONIA PRO 30W
Panel Angle
The solar charge in a battery pack won’t last forever. The off–grid system relies on stored solar energy for autonomy. Angling your solar panels properly can boost the power intake of your solar lighting system. You want to angle your solar panels at a tilt based on the area’s latitude.
Tip
You can increase the tilt 15° in the winter or decrease 15° in the summer.
In this way you can get the maximum sunlight to recharge the battrey
Remote Control Guide
The range of the remote control to the indicator is 16ft (Day time) to 33ft (Night time). Because the sunlight will impact the signal of the remote control, we suggest our users to setup the mode before they install the light.
-
On/Off
When off is selected, the light will stop working. The solar panel will not charge the battery and the battery will not supply electricity to the light. -
Connect/Test
Remote control device can be connected with any lighting fixture. When all cables are connected and solar panel detectes sunlight, the fixture will automatically turn on. To test, press the “Test” button once, the LED light will turn on to indicate the fixture has been turned on. During the day time, the indicator will slowly flashing red. That means the battery is charging. -
40%~100% Motion Sensor Mode
Constant 40% brightness (turns on at dusk, turns off at dawn); 100% brightness turns on for 2 minutes when motion is detected. -
20%~80% Motion Sensor Mode (Default)
Constant 20% brightness (turns on at dusk, turns off at dawn); 80% brightness turns on for 2 minutes when motion is detected. -
Night Owl Mode
Changes as natural light decreases/increases (turns on at dusk); 70% brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, 50% brightness for 1 hour, 20% brightness for 5 hours (turns off at Dawn). -
Early Bird Mode
Changes as natural light decreases/increases with increased brightness near dawn for early risers (turns on at dusk); 70% brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, 50% brightness for 1 hour, 20% brightness for 4 hours, 100% brightness for 1 hour (turns off at Dawn).
Important
Dusk and dawn time may be different in other locations and seasons. The
sensors of our products will follow the light patterns of where it is
installed. The time period shown in the chart above is just an example to help
you understand the different lighting modes only.
-
100% Constant Mode
100% brightness from dusk to dawn. -
70% Constant Mode
70% brightness from dusk to dawn. -
40% Constant Mode
40% brightness from dusk to dawn. -
Timer Mode Disabled
Press this button to turn off Timer Mode; settings revert back to before Timer Mode was last activated. -
Timer Mode 4 Hours
This is an additional mode which can work with any other modes. For example: press this button at any time after you turn on 70% Constant Mode. If the light turns on at 7pm at dusk, it will turn off at 11pm. It will repeat the same schedule hereafter until it is canceled by pressing Timer Mode Disabled. -
Time Mode 8 Hours
This is an additional mode which can work with any other modes. For example: press this button at any time after you turn on 70% Constant Mode. If the light turns on at 7pm at dusk, it will turn off at 3am. It will repeat the same schedule hereafter until it is canceled by pressing Timer Mode Disabled.
(IAP) Intelligent Adaptive Program Battery Control Technology
In order to extend the off-grid autonomy of the CEGONIA PRO 30W under shade trees, heavy rain, and thick clouds, our controllers now integrate an adaptive smart control feature to actively track battery capacity and adjust light output accordingly. Before integrating this feature, selecting a light output percentage on the remote would yield an accurate percentage of max LED brightness. Activating the IAP, the controller actively monitors the battery and regulates the electrical current to the LEDs. The controller makes the light output of a selected percentage on the remote relative to battery capacity rather than max LED output. This smart-control feature can increase the fixture’s off-grid performance by up to 40%.
Important
Dusk and dawn time can vary for different locations and seasons. The sensors in our products will monitor the light levels where it is installed. The time period shown in the chart above is just an example to help you understand the different lighting modes.
CEGONIA PRO products are covered by a 5 year limited warranty. SOLTECH urban light warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 5 years from date of purchase. To obtain warranty service please contact your local distributor or sales rep for further instruction.
1460 Park Avenue.
Emeryville, CA 94608 USA
SOLTECH LLC reserves the right to update all product data sheets at any time. Consult SOLTECH marketing specialists for publication updates athello@soltechlighting.com
Copyright©2022–2023 SOLTECH LLC,
All Rights Reserved.
SOLTECH Designs and Manufactures Advanced, Solar-Powered LED Technology.
Documents / Resources
|
SOLTECH CEGONIA PRO 30W Elegant and Convenient Solar Street
Lighting
[pdf] Installation Guide
CEGONIA PRO, 30W Elegant and Convenient Solar Street Lighting, CEGONIA PRO 30W
Elegant and Convenient Solar Street Lighting, Solar Street Lighting, Street
Lighting
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>