SOLTECH PRO 30W Bronze Solar LED Light User Manual
- June 5, 2024
- SOLTECH
Table of Contents
SOLTECH PRO 30W Bronze Solar LED Light
Introduction
Introduction
Outdoor solar lighting systems use solar cells which convert sunlight into
electricity. Electricity is stored in batteries for use at night. SUNLIKE PRO
solar lights are easy to install and virtually maintenance-free. Using them
won’t increase your electric bill. The range of the light module on the
lighting fixture is 20–26 feet (6–8 meters). The ideal installation spacing is
16 feet(5 meters). When installing two or more lighting fixtures on one pole, select desired operating mode before installation. Interference can cause delay or malfunction when using the remote control to change operating modes after installation. Precautions when working with solar panels When the solar panel is exposed to sunlight, a voltage appears at the output terminals of the solar panel turning it into a source of electricity. To avoid a shock hazard, make sure the solar panel is covered with an opaque (dark) later such as paper or cloth during the installation. Do not make contact with the terminals when the panel is exposed to sunlight or any other light source.
Battery Notes
- Super Capacitor battery-powered SUNLIKE PRO lights are visibly brighter than other outdoor solar lights, and their performance overall is more reliable.
- To charge the battery fully may take up 6 to 12 hours.
- The rechargeable battery can work continuously for 10 hours at full power.
- Output will be reduced to 40% when the battery is below 40% of its capacity.
- The battery will stop charging when the ambient temperature is below -58°F or above 140°F. Battery Status is indicated by the red/green indicator on the lighting fixture as follows:
- Slow red light flashing (Every 2.5s) = Working
- Slow red flashing (Every 5s)= Open circuit
- Red light continuously on = Non-working
- Quick red flashing (Every 0.5s)= Charge fault
- Quick red flashing (Every 0.1s)= Over current or Short circurt Storage To avoid over-discharge of the battery during storage, please recharge the lighting fixture every 4 months. Use the dedicated charger to charge, and reset the switch when done.
Installation and Wiring Compliance
- Installation and wiring must comply with the State and National Electrical Codes.
- The SUNLIKE PRO 30W model is intended for outdoor use only and should not be installed in an unventilated area, and shall be installed in an environment within the operational temperatures defined for the product.
- The average sunshine in the installation area should be above 3.5 hours/day in order to ensure the full functionality of the lighting fixture. Avoid areas with shades.
- Before installation, if applicable, please ensure the light pole and its foundation are solid enough to withstand the lighting fixture(s).
- Before installation, please ensure that the battery is fully charged. Install during sunny days if possible.
- Before installation, please press the ON/OFF key in the remote control and check whether it shows a red light on the indicator. Please cover the panel and check if the light module turns on normally within 1 minute.
Mounting Accessories
Ordering Information Chart
SERIES
|
WATTAGE
|
OPTIC TYPE
| COLOR
TEMPERATURE
| MOUNTING OPTIONS|
FINISH
---|---|---|---|---|---
STLSTCPRO =SUNLIKE
|
30 =30W
|
T2 =TYPE II
|
3 =3000K
|
WM =Wall Mount
|
GY =Gray
PRO| 6000 Lumens| T3 =TYPE III| 4 =4000K| TRR =Trunnion Round|
BR =Bronze
| | T4 =TYPE IV| 5 =5000K| TRS =Trunnion Square|
| | | 6 =5700K| SF =Slip Fitter|
| | | | SA =Straight Arm|
Installation
Panel Angle
The solar charge in a battery pack won’t last forever. The off–grid system
relies on stored solar energy for autonomy. Angling your solar panels properly
can boost the power intake of your solar lighting system. You want to angle
your solar panels at a tilt based on the area’s latitude.
Remote Control Guide
-
40%~100% Motion Sensor Mode Constant 40% brightness (turns on at dusk, turns off at dawn); 100% brightness turns on for 2 minutes when motion is detected.
-
20%~80% Motion Sensor Mode (Default) Constant 20% brightness (turns on at dusk, turns off at dawn); 80% brightness turns on for 2 minutes when motionis detected.
-
Night Owl Mode
Changes as natural light decreases/increases (turns on at dusk); 70% brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, 50% brightness for 1 hour, 20% brightness for 5 hours (turns off at Dawn). -
Early Bird Mode
Changes as natural light decreases/increases with increased brightness near dawn for early risers (turns on at dusk); 70% brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, 50% brightness for 1 hour, 20% brightness for 4 hours, 100% brightness for 1 hour (turns off at Dawn). -
100% Constant Mode 100% brightness from dusk to dawn.
-
70% Constant Mode 70% brightness from dusk to dawn
-
40% Constant Mode 40% brightness from dusk to dawn
-
Timer Mode Disabled Press this button to turn off Timer Mode; settings revert back to before Timer Mode was last activated.
-
Timer Mode 4 Hours This is an additional mode that can work with any other mode. For example: press this button at any time after you turn on 70% Constant Mode. If the light turns on at 7pm at dusk, it will turn off at 11pm. It will repeat the same schedule hereafter until it is canceled by pressing Timer Mode Disabled.
-
Time Mode 8 Hours This is an additional mode that can work with any other mode. For example: press this button at any time after you turn on 70% Constant Mode. If the light turns on at 7pm at dusk, it will turn off at 3am. It will repeat the same schedule hereafter until it is canceled by pressing Timer Mode Disabled.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>