NOKIA BH-205 Noise Cancelling Earbuds User Guide
- June 6, 2024
- Nokia
Table of Contents
NOKIA BH-205 Noise Cancelling Earbuds
What’s in the box
- Charging Case
- Earbuds (L/R)
- Ear Tips (5/M/L
- USB Type-C cable
- Quick Start Guide
Product overview
- Charging contacts (L)
- Charging contacts (Rl
- Battery status LEDs
- Reset button
- USB Type-C port
- LED indicator light
- Microphone
- Touch control area
- Ear tip
Power on
When you open the charging case, the earbuds will turn on and pair with
each other automatically. During the pairing process, the LED indicator lights
will flash orange and white alternately. When they have successfully paired,
the LED indicator light of the right earbud will flash white rapidly and the
earbuds are ready to connect with your Bluetooth® device.
Pairing
-
The LED indicator lights of the earbuds will flash white when they are successfully connected with your Bluetooth device
-
After the initial pairing, the earbuds will automatically connect with your Bluetooth device whenever the charging case is opened.
-
Connect with another device:
- Turn off Bluetooth in the device to which the earbuds are connected (now the earbuds can be searched by other devices) > repeat the step 2 to connect with another device
- The earbuds will automatically power off if there is no Bluetooth connection within 5 minutes. (Exception: if the ANC mode is active, the earbuds will not turn off automatically.
-
Reset (facing operation abnormal or to delete pairing records):
Place the earbuds back in the charging case (keep the case open) > press and hold the reset button for 5 seconds, the Battery status LEDs on the charging case flash white (enter the reset process) > the LED indicator lights of the earbuds flash orange and white alternately (the reset is successful and the earbuds enter the pairing process).
Charging
-
Charge the charging case
Connect the USB Type-C cable to a power source to begin charging. The battery status LEDs show the current battery status while opening the charging case. -
Charge the earbuds
Earbuds’ LED indicator lights turn orange when charging, and turn off when fully charged. If the earbud is low in battery power, the LED indicator light will flash orange every 5 seconds.
Touch Controls
You can switch the modes by holding the touch control area for 1.5 seconds as below: ANC mode (Active Noise Cancelling) > Ambient mode > off
Troubleshooting
you can use a single earbud. If the earbuds have been paired with your Bluetooth device before, it will automatically connect with your device when taken a single one out of the charging case.
Product and safety information
Remote control functions may vary depending on the model of your device and
application. Soundtrack instructions do not respond to iOS devices. Since
devices with Bluetooth wireless technology
communicate using radio waves, they do not need to be in direct line of sight.
Bluetooth devices must, however, be within 1 O meters (33 feet) of each other,
although the connection may be subject to interference from obstructions such
as walls or from other electronic devices.
Frequency Band: 2402 MHz – 2480 MHz
Maximum Radio Frequency Power:< 10 dbm/MHz
For your safety
Switch off in restricted areas
Switch the device off when a Bluetooth headset use is not allowed or when it
may cause interference or danger, for example, in aircraft, in hospitals or
near medical equipment, fuel, chemicals, or blasting areas. Obey all
instructions in restricted areas.
interference
All wireless devices may be susceptible to interference, which could affect
performance.
Batteries, chargers, and other accessories
Use only batteries, chargers, and other accessories approved by HMO Global Oy
for use with this device. Do not connect incompatible products.
Protect your hearing
To prevent possible hearing damage, do not listen at high volume levels for
long periods.
Hearing
Warning: When you use the headset, your ability to hear outside sounds
may be affected. Do not use the headset where it can endanger your safety.
Small children
Your device and its accessories are not toys. They may contain small parts. Keep them out of the reach of small children
Take care of your device
Handle your device with care. The following suggestions help you keep your device operational
- Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrode electronic circuits.
- Do not use or store the device in dusty or dirty areas.
- Do not store the device in high temperatures. High temperatures may damage the device or battery.
- Do not store the device in cold temperatures. When the device warms to its normal temperature, moisture can form inside the device and damage it.
- Do not open the device other than as instructed in the user guide.
- Do not drop, knock, or shake the device or the battery. Rough handling can break it.
- Only use a soft, clean, dry cloth to clean the surface of the device.
- Do not paint the device. Paint can prevent proper operation.
- The earbuds are featured with water protection level IPXS. Water protection level is not a permanent condition and can decrease over time.
- The charging case is not water-resistant
Recycle
Always return your used electronic products, batteries, and packaging
materials to tS, dedicated collection points. This way you help prevent
uncontrolled waste disposal and promote the recycling of materials. Electrical
and electronic products contain a lot of valuable materials, including metals
(such as copper, aluminum, steel, and magnesium) and precious metals (such as
gold, silver, and palladium). All materials of the device can be recovered as
materials and energy.
Crossed-out wheelie bin symbol
Do not dispose of these products as unsorted municipal waste: take them for recycling. For info on your nearest recycling point, check with your local waste authority.
Battery info
Your device has an internal, non-removable, rechargeable battery. Do not
attempt to remove the battery, as you may damage the device. The battery can
be charged and discharged hundreds of times, but it will eventually wear out.
Charging time can vary depending on device capability.
Battery safety
If left unused, a fully charged battery will lose its charge over time.
Always keep the battery between 15°C and 25°C (59° F and 77°F) for optimal
performance. Extreme temperatures reduce the capacity and lifetime of the
battery. A device may temporarily stop working if its battery is too hot or
too cold. Do not dispose of batteries in a fire as they may explode. Obey
local regulations. Recycle when possible. Do not dispose of as household
waste. Use the battery for its intended purpose only. Improper use of, or use
of unapproved or incompatible, batteries may present a risk of fire,
explosion, or another hazard, and may invalidate any approval or warranty. If
you believe the battery is damaged, take it to a service center or your local
shop before continuing to use it. Never use a damaged battery. Do not charge
your device during a lightning storm.
Implanted medical devices
To avoid potential interference, manufacturers of implanted medical devices
recommend a minimum separation of 15.3 centimeters (6 inches) between a
wireless device and the implanted medical device. Persons who have such
devices should:
- Always keep the wireless device more than 15.3 centimeters {6 inches) from the medical device.
- Not carry the wireless device in a breast pocket.
- Switch the wireless device off if there is any reason to suspect that interference is taking place.
- Follow the manufacturer directions for the implanted medical device
If you have any questions about using your wireless device with an implanted medical device, consult your health care provider.
FCC statement
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Copyrights and other notices
The availability of products, features, apps and services may vary by region.
For more info, contact your dealer or your service provider. This device may
contain commodities, technology or software subject to export laws and
regulations from the US and other countries. Diversion contrary to law is
prohibited.
The contents of this document are provided “as is”. Except as required by
applicable law, no warranties of any kind, either express or implied,
including, but not limited to, the implied warranties of merchantability and
fitness for a particular purpose, are made in relation to the accuracy,
reliability, or contents of this document. HMD Global reserves the right to
revise this document or withdraw it at any time without prior notice.
Reproduction, transfer, or distribution of part or all of the contents in this
document in any form without the prior written permission of HMO Global is
prohibited. HMO Global operates a policy of continuous development. HMO Global
reserves the right to make changes and improvements to any of the products
described in this document without prior notice.
Manufacturer and importer in EU: HMO Global Oy, Bertel Jungin aukio 9, 02600
Espoo, Finland. HMO Global Privacy Policy, available at http·/www.Nokia
mm/phones/privacy applies to
your use of the device.
In the unlikely event that this product is faulty, please return it to the
store where you purchased it with your proof of purchase. For more information
on this or other products please visit
In the unlikely event that this product is faulty, please return it to the
store where you purchased it with your proof of purchase. For more information
on this or other products please visit
http-//www.nokia.com/phones/support-
© 2021 HMO Global. All rights reserved. HMO Global Oy is the exclusive licensee of the Nokia brand for phones & tablets. Nokia is a registered trademark of Nokia Corporation.
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by HMO Global is under license.
Declaration of Conformity
Hereby, HMO Global Oy declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. A copy of the Declaration of Conformity can be found www.nokia.com/mobile- declaration-of-conformity
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>