arvig GigaSpire BLAST u4m Setup User Guide
- June 6, 2024
- arvig
Table of Contents
arvig GigaSpire BLAST u4m Setup
QUICK START GUIDE
-
Connect GigaSpire BLAST u4m to power outlet.
-
When the LED is flashing red, you can pair the GigaSpire BLAST u4m with the GigaSpire BLAST u4. Press and hold the WPS buttons on the GigaSpire BLAST u4m and then the
GigaSpire BLAST u4 for 3 seconds each (less than 30 seconds apart). The LED flash green while attempting to pair.
Note: Once successful pairing is complete, the GigaSpire BLAST and GigaMesh LEDs will both show a solid cyan (light blue) color. It may take several minutes to reach this state.
-
Use the solid green LED indicator (displays for 60 seconds at end of pairing cycle) to determine ideal location for the GigaMesh. If necessary, relocate it to a more ideal distance
from the GigaSpire BLAST and confirm successful pairing after the GigaMesh reboots (repeating steps 2-3 as needed).
GigaSpire BLAST u4m location is ideal distance from the GigaSpire BLAST u4.
Ideal: Steady State
-
If applicable, use the Arvig® Manage Your WiFi app to set up the GigaSpire BLAST. See the Arvig Manage Your WiFi Quick Start Guide for guidance.
Need help?
877.290.0560 | arvig.net/managedwifi
Based on Arvig service area; some restrictions apply. ©Arvig 2021 Item263
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>