ThermoMart DO101-4CH Smart WiFi Hot Tub Spa Pool Side Remote Control Instructions
- June 6, 2024
- ThermoMart
Table of Contents
Wiring
Please be sure that the Spa’s circuit breaker is off and there is no power in
your control panel. Check the manual of your Spa for wiring and connecting
this device to your inside remote function. Usually, there is a remote
terminal with 5 inputs. One of the inputs is COM and the other 4 are your
remote functions (like Spa, Light, Heater, Jet). We show these 4 functions in
the following diagram but please consider that, where your side remote
functions on your Spa is connected to the PCB board too. After connecting the
wires, you can turn ON/OFF and rename your WiFi device 4 switches as you see
the functions on your Spa.
If you are not comfortable doing wiring you should consult a qualified
electrician and it is carried out at your own risk. Please contact us if you
need help with wiring.
Device Specifications: Device comes with 5V DC adapter Board consumption: <1W
Standby current: 80mA Max output current: 16Amp Supports to control different
voltage ranges Relay lifespan: more than one million times Relay maximum pull
time: 15ms Relay maximum release time: 5ms
Device Specifications:
- The device comes with a 5V DC adapter
- Board consumption: <1W
- Standby current: 80mA
- Max output current: 16Amp
- Supports to control different voltage ranges
- Relay lifespan: more than one million times
- Relay maximum pull time: 15ms
- Relay maximum release time: 5ms