Rolgno M2 Magnetic Wireless Car Charger User Manual

Table of Contents

Rolgno M2 Magnetic Wireless Car Charger

Rolgno M2 Magnetic Wireless Car Charger

Note: For the best performance and safety, please read this manual carefully before using the product.

Unscrew the locking nut from the back of the mount.
Place the nut around the ball joint, and push it into the back of the mount.
Tighten the nut clockwise.
Loosen the grip locking knob clockwise, then attach the clamp to the car vents and tighten the knob.
Connect the power supply using the cable and car charger included. Note: Must use the car charger with outputs of at least 18W.
Put the phone into the mount, the charger will automatically absorb the phone and align it with the charging center.

Note

When the device is connected to the power supply, the blue indicator light will light up. When the phone starts charging, the indicator light will be off. If the phone is removed, the indicator light will light up again.
The charger has a foreign object-sensing function. When metal or magnetic objects are near the charging pad, the indicator light will flash. Please remove the relevant items to avoid affecting the wireless charging function.

This charger is only compatible with iPhone 12/13/14 and later series.
The maximum output of this charger is 15W. Its maximum output for iPhones is 7.5W.
Please only use the cable provided with the charger.
Other third-party cables may interfere with charging.
This charger requires a car charger that supports QC3.0 or PD fast charging. It is recommended to use the included car charger.
The charging pad is equipped with a magnetic ring.
Please remove the phone case or use a magnetic suction phone case when using it.

Do not place the device in temperatures below 0°C （32°F）or above 60°C（140°F).
Do not expose it to an open flame, or submerge it in water to avoid damaging the device.
Do not attempt to disassemble or modify the device in any way, as it may cause serious damage and void the warranty.
Do not expose the device to extremely hot, humid, or corrosive environments to avoid damaging the device.
Before charging, please remove all metal or magnetic accessories from the device that may interfere with wireless charging. Metal rings, magnetic cards, and credit cards will affect the wireless charging function.
Keep out of reach of children

Symbol

MADE IN CHINA

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation Is subject to the following two conditions:

this device may not cause harmful interference, and
this device must accept any interference received, ln clouding interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful Interference In a residential installation\ This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that Interference will not occur In a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and an, the user Is encouraged to try ta correct the lnter1erence by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment Into an outlet on a circuit different from that to which the receiver Is connected.
Consult the dealer or an experienced radio/TV technician for help.