myxfitness P5-MYX2 Power Meter Crank Instruction Manual
- June 6, 2024
- myxfitness
Table of Contents
myxfitness P5-MYX2 Power Meter Crank Instruction Manual
Power Meter Location
Before use, take out the battery insulation sheet
-
Use your finger or nail to align the battery door paddle and turn the battery door in the direction indicated by the arrow;
-
After removing the battery insulation sheet, put the battery cover (including the battery) into the battery compartment;
-
Pay attention to the alignment of the battery door paddle as shown below;
While pressing the battery door inward, align your finger or nail on the battery door paddle and reverse the direction indicated by the arrow,push, the LED light on the side of the sensor flashes to indicate that the installation is correct.
Replace battery
-
Use your finger or nail to align the battery door paddle and turn the battery door in the direction indicated by the arrow.
-
Take out the battery door, find the metal battery bracket in the battery door, remove the bracket, you can take out the old battery and turn the positive side of the new battery toward the metal bracket.and put it into the battery door, and install battery door into battery compartment as the steps
above.
Caution: Do not allow children to touch the battery to avoid danger, The product has a built-in battery. Do not throw the product into a fire. -
Pay attention to the alignment of the battery door paddle as shown below;
While pressing the battery door inward, align your finger or nail on the battery door paddle and reverse the direction indicated by the arrow,push, the LED light on the side of the sensor flashes to indicate that the installation is correct.
- LED Flash colors: Battery install successful
- Green LED flash 3 seconds : Bluetooth connected
- Battery type: CR2032 coin battery
FCC Statement
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>