EraClean CW-BS01 Refrigerator Odor Eliminator Max User Manual
- June 6, 2024
- EraClean
Table of Contents
EraClean CW-BS01 Refrigerator Odor Eliminator Max User Manual
User Manual for Refrigerator Odor Eliminator Max
CW-BS01
Thank you for purchasing our product, for better experience, please read
carefully the above content and keep it properly.
The product is compatible with Mi Home App.
To connect with Mi Home, firstly please download and install Mi Home,
You can search Mi Home in app store to finish the step. Mi home users will be
lead to the device-connecting page by scanning the QR code in product.
Scan the QR code in product
-
Add device
1.Long press the switch for 5 seconds to start the device-connecting step (during connecting, the blue light will be on and flowing. After connected, the blue light will be on and last for 5 secs.)
2.Open Mi Home and log in your account
3.Click the “+” in the upper right corner of the app, you’ll go to the add- devices page
4.Click “ ” in the upper right corner of the page, scan the product QR code and finish the step by guidance.
Notes: In case the QR code is not able to be scanned, you can add the device by searching product name. -
As Mi Home will be updated from time to time, the actual operation might have little differences, please follow Mi Home’s guidance to finish all steps.
-
Product introduction
-
Use Instruction
01.Fresh mode
Click the switch once to start the fresh mode
02.Anion Mode
Click the switch twice to start the anion mode -
Deep deodorize mode
Click the switch three times to start the deodorize mode -
Battery indicator
Click the switch four times to check the battery capacity. If the indicator is blue and always on, means the powers’ sufficient. If the indicator is red and always on, means the powers’ not enough. -
Install the hook
Install the hook in the hook hole if needed
3.Product Parameters
Product name: Refrigerator Odor Eliminator Max
Model# CW-BS01
Rated voltage: 5V
Rated current: 1A
Rated power: 2W
Battery capacity: 3000mAh
Product dimension：158mmx48mmx39mm
N.W: 180g
Standard: GB 4706.1-2005
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>