Guangdong Eraclean Technology GFC01 Portable Fruit and Vegetable Cleaner User Manual
- June 6, 2024
- Guangdong Eraclean Technology
Table of Contents
Operating Manual of Portable Fruit and Vegetable cleaner
GFC01
*Thank you for purchasing our products. Please read the instructions carefully before working on this product for a better experience, and keep it properly.
Product Introduction
This product applies to clean residues and bacteria from the surface of vegetables and fruits, as well as sterilizes various kitchen utensils. According to the actual using conditions, this product can be placed in the household kitchen basin or sink or can be placed in other convenient and sanitary plastic bags or sanitary watertight containers when going out, which is convenient to use.
Parts list
Specifications
Product Name: Portable Fruit and Vegetable cleaner
Product Model: GFC01
Rated Power: 10W
Rating Charging Voltage: 5V
Battery Capacity: 4400mAh
Rating Charging Current: 1.3A
Charging Time: ≤8H
Waterproofing Grade: IPX7
Dimension: 106 mmx74 mm(including charging dock)
Net Weight: approx. 0.44 Kg (including charging dock)
Executive Standard: GB4706.1
*Product specifications, appearance, and design are subject to change without prior notice.
Safety Precautions
To ensure the safety of use and avoid injury or property loss, please observe the following safety precautions. Otherwise, the incorrect operation may lead to accidents without complying with safety precautions.
| stands for prohibited contents | **** stands for mandatory contents |
|---|
It is strictly prohibited to immerse the wireless charging dock in water
or other liquids to avoid danger.
The persons, including children, the elderly or disabled, and people
without experience should use the product under supervision and guidance.
Please contact after-sales personnel and seek original accessories or
correct models to replace and avoid risks when the wireless charging dock or
charging cable is damaged.
Please do not use the product again with any damage. The feasible
approach is to contact the customer service of the company and send the
product back for repair. Please note that users are forbidden to repair by
themselves.
The product has a built-in lithium battery, please do not expose the
product to high temperature or fire, and do not discard the product as general
garbage.
Please do not use the product in places with inflammable and explosive
gases or in gas stations.
Safe disposition of battery.
–The battery of this product should not be replaced by the user.
–Please be sure to remove the battery from the appliance before discarding it.
–Please make sure the appliance must be powered off when removing the battery.
–Battery should be disposed of safely.
Please do not charge on tilted or unstable tabletops, and do not get
close to or placed on any electrical appliances.
The host is matched with the charging dock, it is forbidden to use other
charging docks as matching apparatus.
Please do not use metal objects to touch the electrode to avoid a short
circuit of the electrodes, leading to abnormal operation.
Please avoid colliding when using the exposed electrolysis electrode,
which is the working part of the product. To avoid the deformation of the
electrode, leading to abnormal operation.
Please do not insert pins, iron wires, or other conductive objects
between the two electrodes to avoid a short circuit of the electrodes, leading
to abnormal operation.
Please do not operate this product unattended.
Please unplug the charger from the power socket without the requirement
of charging.
To avoid the abnormal operation of the machine, it is not recommended to
clean meat and fatty tableware.
It is feasible to use a brush to wash the surface of the electrolytic
sheet for abnormal working problems caused by an oil residue.
**** The product can only work in tap water at normal temperatures. Water
beyond normal temperature will lead to the disable or damage of the product.
Instructions
| 1. Please place the host on the charging dock to charge before using for
the first time.
---|---
| 2. Please plug the power adapter in the household power supply after
connecting one end of the USB cable to the port and the other end to the power
adapter (please use 5V2A specification).
| 3. Place the host on the wireless charging base, with centers aligned, and
then start charging.
| 4. The circular-formed indicator light will flash with alternate colors of
red and green on the charging process. The green light will continue on when
the charging is finished.
| 5. Please pour water into the container (the purifier can purify 2-6 liters
of water), and place the host in the vegetable basin or the sink (you can
choose the container you like, which will not affect the performance of the
product), and keep the host horizontal and up at the bottom of the container.
| 6. Power-on: Press the control button, and the green light of the circular-
formed indicator will be on and there will be a beep, representing that the
washer is in the standby mode (if there is no other operation within 30
seconds, it will be off automatically). Press again, and with a beep, the green
circular-formed indicator and blue work indicator will flash simultaneously,
the product starts to work. The product will be off automatically after the
task is completed.
| 7. Please stir the clearing materials from time to time during the
operation for better purification effect
| 8. After the operation (all indicator lights off), please stand for about 5
to 10 minutes and take the cleaning materials out and then rinse it with clean
water; If there is too much water in the container, the user can set the times
for reboot according to the actual situation.
| 9. Please do not use the product to avoid damage if there is no water in
the container or the device is not completed immersed.
| 10. The material of the charging base is not waterproof. Please do not
place the device in the environments associated with submerging, showering,
which is humid.
| 11. It is advisable to place the host that is fully charged in your
traveling bag, which will be convenient for use when going out.
Environment:
Please do not place it with general household waste when disposing of the product. It should be sent to the recycling center set by the government, which will be environmentally friendly.
Routine Maintenance
Please keep the pane free from foreign materials,
which will lead to a failure in operation.
|
When there are some foreign materials in the device, please rotate the up lid anticlockwise and clean it.
|
Please use a hairbrush with proper width for cleaning and keep the weep hole unblocked.
---|---|---
Please do not try opening this lid, because this may lead to product failure
which you can not restore
properly.
|
Please do not try removing this silicone piece for cleaning in detail, which may lead to the failure of the control buttons. Please do not remove the screw for cleaning, because this may lead to product failure. If any help is needed, please contact the after-sales service worker.
Troubleshooting
FAQ
| Reason|
Solution
---|---|---
The product cannot work| Not enough power| Press the button for standby mode
and check if the indicator will be on.
Please have a check if the green and red circular-formed indicator lights flash
alternately when charging.
The product cannot be charged.| The product may not be placed in the specified
environment when charging.| Check whether the host is aligned with the center
of the wireless charging base.
Check whether the host is charged on a dry and level table and whether it
meets the requirements of the charging specification in the instruction manual.
Make sure that there are no metals placed under the charging base when
charging.
The supply voltage to which the product is connected may not match the product
voltage.| Make sure that the supply voltage is consistent with the voltage
marked on the product label.
The power socket to which the product is connected
may be damaged.| Check whether the device is correctly connected.
Check the fuses of the power socket.
Small or weak bubbles.| The product is used to clean meat or greasy utensils
and tableware.| Check if the product is used to clean meat or if the product
is greasy. Soak the product with a small amount of detergent for 30 minutes,
rinse it with water until it is clean. Put the device in the tap water
container and start it, observe whether it returns to normal.
Toxic and Hazardous Substance Statement for Electronic Information
Product
Name and Contents of Hazardous Substance in the Product
| Part Name | Hazardous Substance |
|---|---|
| Pb | Hg |
| Shell |
Ο
|
Ο
|
Ο
|
Ο
|
Ο
|
Ο
Circuit Board| Ο| Ο| Ο| Ο| Ο|
Ο
Accessory|
Ο
| Ο| Ο| Ο| Ο|
Ο
The form is formulated according to the regulations of SJ/T 11364.
Ο: represents that the content of the toxic and hazardous substance in all
homogeneous materials of the part is below the limit specified in GB/T 26572.
×: represents that the content of the toxic and hazardous substance in any
homogeneous materials of the part is beyond the limit specified in GB/T 26572.
After-sales Services
The quality warranty period is one year from the purchasing date.
Warranty Services
- For the consideration of your rights and interests, please take good care of the warranty card after purchasing this product. The warrant card is an important voucher for warranty services.
- Upon the discovery of any fault arising from a quality defect, please call our customer service telephone at 400-809-9977 or submit an after-sales service application through the official website of EraClean. Our service staff will be glad to provide the best solution to you at the first convenient time.
- If you come across any fault of the product beyond the scope of free warranty services or encounter any fault after your product is beyond the warranty period, you may select compensated repair services. For details about such services, please consult with our customer service staff. We will test the machine and then provide the corresponding repair services according to the actual situations.
Faults beyond the Scope of Warranty Services
- The product is beyond the valid period of three-warranty services or the warranty period.
- The product is used in commercial applications for profit-making purposes without the authorization of EraClean.
- Damage of the products caused by failing to use, maintain, and service of the product according to requirements in the User Manual, or using of any accessories other than the original accessories.
- Collision, fal l ing off or squeezing of the product caused by authorized repair or alteration, or any other man-made reasons.
- The label, sealing strips, and serial number could not be identified due to behaviors like tear-off or obliteration.
- Consumables are not within the scope of warranty services.
- Faults are caused by the application of the product beyond the permitted conditions or environment.
- Faults and damages of the product caused by force majeure factors (like natural disasters, governmental actions, social abnormal events, etc.)
After-Sales Warranty Card
Warranty Card(original for sales)
User Name:——————–□ Sir □ Madam Contact Number:——————————————–
Address:————————————————————————————————————–
Product Model:————————-Serial No. on the Main Body:—————————————-
Date of Purchasing:————————————————————————————————
Invoice No.:———————————————————————————————————
(Stamp of the Seller)
Warranty Card(copy for sales)
User Name:—————–□ Sir □ Madam Contact Number:———————————————-
Address:————————————————————————————————————
Product Model:———————-Serial No. on the Main Body:—————————————–
Date of Purchasing:———————————————————————————————-
Invoice No.:——————————————————————————————————-
(Stamp of the Seller)
Certificate of Quality
Authenticated
Verified by
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF exposure guidelines, This equipment should be installed and operated with a minimum distance of 20cm of the radiator of your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>