SOLTECH NUVO 25W Solar LED Wall Light Instruction Manual
- June 6, 2024
- SOLTECH
Table of Contents
SOLTECH NUVO 25W Solar LED Wall Light
INTRODUCTION
- Do not install the lamp away from the sun, under a shade, or between high buildings that will cover the lamp. It will affect sunlight absorption and shorten the lamp’s autonomy.
- Do not use the lamp in areas with temperatures above 113°F or below 32°F or it will cause a rapid attenuation of the battery affecting battery life and damage to the battery.
- Do not use non-standard installation accessories to install the lamp, otherwise, the installer will be responsible for any accident or damage.
- Choose the appropriate operating mode based on your local sunshine.
Warning
- Keep the device away from fire and oil to avoid any fire or explosion.
- Only professional technicians should attempt to disassemble the lamp in order to avoid any damage to the lamp.
- It is not advised to disassemble the battery for personal use.
- If the lamp does not receive a charge for 3 days, the battery might run out of battery. You will need to charge it underneath bright sunlight.
- In order for the lamp to work in an ideal state for a long time, please clean the solar panel according to local dust conditions at least once a year.
SPECIFICATIONS
| POWER / LUMEN | 25W / 2,500LM |
|---|---|
| LED | 2835 50PCS |
| LI-ION BATTERY | 2,000mAh / 3.7V |
| SOLAR PANEL | 1.0 W, Mono-crystalline Silicon |
| CHARGING TIME | 18 hrs |
| RUN TIME@FULL POWER | >10 Days |
| WORKING MODE | 3 Different Modes |
| DETECTION ANGLE / AREA | 120° / 19.7ft |
| CHARGING TEMP | 32°F–113°F |
| IP DEGREE | IP65 |
| WARRANTY | 3 YEARS |
| LIFESPAN | 35,000 hrs |
| INSTALLATION HEIGHT | ≤8.2 ft |
| PACKING | Solar Light X 1, Screw Bag X 1, |
User Manual X 1
INSTALLATION
- Measure the hole drillings then drill 2 holes
- Fix the expansion plugs into the holes
- Fix the lamp on the wall and secure it with the screws
Face the solar panel toward the sun to effectively charge the built-in Li-ion battery.
OPERATING MODES
- PRESS BUTTON TO SELECT WORKING MODE: Long Press 1.5s for TURN ON / OFF
- MODES SWITCH: Short press it to change lighting mode
- MODE SWITCH WITH RED LED INDICATOR:
MODE A: Flashing 1 time, 50Lm + PIR 2,500Lm 10s
MODE B: Flashing 2 times, 0Lm + PIR 2,500Lm 10s
MODE C: Flashing 3 times, 50Lm to dawn
MODE A:
Automatically turns on to weak brightness (50Lm). When motion is detected in
the range of 19.7 ft, the fixture turns to full brightness (2,500Lm) for 10
seconds.
MODE B:
Automatically turns off. When motion is detected in the range of 19.7 ft, the
fixture turns to full brightness (2,500Lm) for 10 seconds.
MODE C:
Automatically turns on to weak brightness (50Lm) until dawn.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>