OYPLa 2459 30L Water Filled Garden Lawn Roller User Manual
- June 6, 2024
- Oypla
Table of Contents
OYPLa 2459 30L Water Filled Garden Lawn Roller
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all
equipment, we cannot guarantee freedom from injury. The user assumes all risk
of injury due to use. All merchandise is sold on this condition, which no
representative of the company can waive or change.
- Make sure all bolts are secured before using. The user takes all responsibility for the construction and use of the product.
- Please make sure that the plug (found on the side of the 30L tank) is secure once you have filled the tank with water. If the plug isn’t secure it could dislodge itself and cause the water to escape.
- Leaving the product outside exposed to weather, especially direct sun, rain and salt air, will speed the weathering process. This can be slowed by removing the product from these conditions, or covering it with a suitable cover.
- This product is not a toy, and is only to be used for its designated purpose.
- Do not carry out alterations or modifications to this product.
- This product is intended for outdoor use only.
- Clean only with a damp cloth. Do not use strong industrial cleaning substances.
- If the product is damaged or has any defects, please contact cservice@oypla.com
30KG WHEN FILLED WITH WATER
45KG WHEN FILLED WITH SAND
Assembly Instructions
Parts List
If you are missing any of the below parts please contact
cservice@oypla.com
Please be aware that you will be referring to this parts list throughout the
assembly process.
Do not tighten fixings until all nuts, bolts and washers are in the correct position
- Assemble the left arm by attaching the lower arm section to the handle (2) using two bolts (5) and secure in place using a washer (6) and nut (7).
- Repeat this process with the right arm.
- Attach the arms to the drum axle using the axle bolts (8)
- Attach the scraper bar (4) to the arms using a bolt, washer and nut (5, 6, 7) on each side.
- Check the handle is square and the cross bar/scraper is not touching the roller drum and then tighten all the fixings.
- Turn the roller drum so that the cap/cork/plug (8) is upwards and then fill with water or sand.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>