SOLTECH VIOS Solar LED Wall Light Instruction Manual
- June 6, 2024
- SOLTECH
Table of Contents
SOLTECH VIOS Solar LED Wall Light Instruction Manual
1460 Park Avenue. Emeryville CA 94608 USA www.soltechlighting.com
Please read and follow all instructions to operate. Save this manual for future reference.
SOLTECH LLC reserves the right to update all product data sheets at any time. Consult SOLTECH marketing specialists for publication updates at www.soltechlighting.com Copyright©20212022 SOLTECH LLC, All Rights Reserved.
01 INTRODUCTION
- This is a solar powered lamp, please install it in a location where it can get enough sunshine.
- Please note the duration of the light depends on sun intake & weather.
- The lamp will automatically turn on at dusk. 4. Built-in IC with over-charge, over-discharge, and over-voltage protection.
Warning
- The lamp is equipped with internal batteries. Non-professionals please do not disassemble the lamp.
- Please do not dispose the battery in household garbage to avoid explosion.
02 SPECIFICATIONS
03 INSTALLATION
- Please use the measure card to correctly position the hole drillings then drill 3 holes of 6mm
- Fix 3 expansion plugs into the holes
- Fix 3 screws into the expansion plugs leaving spare space to hang & secure the light.
- Hang the notch onto the screws and fasten the lamp
- Press the power button on the back to program the operating mode
04 OPERATING MODES
Please press the power button to program an operating mode:
Press 1 time for MODE A
Press 2 times for MODE B
Press 3 times for MODE C
Press 4 times to TURN OFF
MODE A
Automatically turn on at dusk (< 30 Lux) and remains at 20% brightness for 5
hours then turns off.
MODE B
Automatically turns on to full brightness (800LM) when motion is detected in
the range 19.7ft and then dims to 3% brightness in 20 seconds of no motion.
MODE C
Automatically turns on to full brightness (800LM) when motion is detected in
the range 19.7ft and then turns off in 30 seconds of no motion.
